imx/mx3: depend on USB_ULPI for otg_ulpi_create
otg_ulpi_create is defined in drivers/usb/otg/ulpi.c which depends on
CONFIG_USB_ULPI. So protect its usage by the same symbol. Moreover
mxc_ulpi_access_ops needs CONFIG_MXC_ULPI.
Signed-off-by: Uwe Kleine-König <u.kleine-koenig@pengutronix.de>
Cc: Sascha Hauer <s.hauer@pengutronix.de>
Cc: Valentin Longchamp <valentin.longchamp@epfl.ch>
Cc: Daniel Mack <daniel@caiaq.de>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
diff --git a/arch/arm/mach-mx3/mx31lite.c b/arch/arm/mach-mx3/mx31lite.c
index 4697164..789b20d 100644
--- a/arch/arm/mach-mx3/mx31lite.c
+++ b/arch/arm/mach-mx3/mx31lite.c
@@ -135,6 +135,7 @@
* USB
*/
+#if defined(CONFIG_USB_ULPI)
#define USB_PAD_CFG (PAD_CTL_DRV_MAX | PAD_CTL_SRE_FAST | PAD_CTL_HYS_CMOS | \
PAD_CTL_ODE_CMOS | PAD_CTL_100K_PU)
@@ -180,6 +181,7 @@
.portsc = MXC_EHCI_MODE_ULPI | MXC_EHCI_UTMI_8BIT,
.flags = MXC_EHCI_POWER_PINS_ENABLED,
};
+#endif
/*
* NOR flash
@@ -256,11 +258,13 @@
mxc_register_device(&mxc_spi_device1, &spi1_pdata);
spi_register_board_info(&mc13783_spi_dev, 1);
+#if defined(CONFIG_USB_ULPI)
/* USB */
usbh2_pdata.otg = otg_ulpi_create(&mxc_ulpi_access_ops,
USB_OTG_DRV_VBUS | USB_OTG_DRV_VBUS_EXT);
mxc_register_device(&mxc_usbh2, &usbh2_pdata);
+#endif
/* SMSC9117 IRQ pin */
ret = gpio_request(IOMUX_TO_GPIO(MX31_PIN_SFS6), "sms9117-irq");