[ARM] Kirkwood: rationalize NAND setup a bit
Common resource and platform device structures are moved to common.c
and only the partition table and chip delay remains a per board
parameter.
Signed-off-by: Nicolas Pitre <nico@marvell.com>
diff --git a/arch/arm/mach-kirkwood/rd88f6281-setup.c b/arch/arm/mach-kirkwood/rd88f6281-setup.c
index 31e996d..31708dd 100644
--- a/arch/arm/mach-kirkwood/rd88f6281-setup.c
+++ b/arch/arm/mach-kirkwood/rd88f6281-setup.c
@@ -12,7 +12,6 @@
#include <linux/init.h>
#include <linux/platform_device.h>
#include <linux/irq.h>
-#include <linux/mtd/nand.h>
#include <linux/mtd/partitions.h>
#include <linux/ata_platform.h>
#include <linux/mv643xx_eth.h>
@@ -22,7 +21,6 @@
#include <asm/mach/arch.h>
#include <mach/kirkwood.h>
#include <plat/mvsdio.h>
-#include <plat/orion_nand.h>
#include "common.h"
#include "mpp.h"
@@ -42,32 +40,6 @@
},
};
-static struct resource rd88f6281_nand_resource = {
- .flags = IORESOURCE_MEM,
- .start = KIRKWOOD_NAND_MEM_PHYS_BASE,
- .end = KIRKWOOD_NAND_MEM_PHYS_BASE +
- KIRKWOOD_NAND_MEM_SIZE - 1,
-};
-
-static struct orion_nand_data rd88f6281_nand_data = {
- .parts = rd88f6281_nand_parts,
- .nr_parts = ARRAY_SIZE(rd88f6281_nand_parts),
- .cle = 0,
- .ale = 1,
- .width = 8,
- .chip_delay = 25,
-};
-
-static struct platform_device rd88f6281_nand_flash = {
- .name = "orion_nand",
- .id = -1,
- .dev = {
- .platform_data = &rd88f6281_nand_data,
- },
- .resource = &rd88f6281_nand_resource,
- .num_resources = 1,
-};
-
static struct mv643xx_eth_platform_data rd88f6281_ge00_data = {
.phy_addr = MV643XX_ETH_PHY_NONE,
.speed = SPEED_1000,
@@ -114,6 +86,7 @@
kirkwood_init();
kirkwood_mpp_conf(rd88f6281_mpp_config);
+ kirkwood_nand_init(ARRAY_AND_SIZE(rd88f6281_nand_parts), 25);
kirkwood_ehci_init();
kirkwood_ge00_init(&rd88f6281_ge00_data);
@@ -129,8 +102,6 @@
kirkwood_sata_init(&rd88f6281_sata_data);
kirkwood_sdio_init(&rd88f6281_mvsdio_data);
kirkwood_uart0_init();
-
- platform_device_register(&rd88f6281_nand_flash);
}
static int __init rd88f6281_pci_init(void)