| Roland Dreier | 217d115 | 2007-10-15 13:57:46 +0200 | [diff] [blame] | 1 | #ifndef _ASM_X86_SERIAL_H |
| 2 | #define _ASM_X86_SERIAL_H |
| 3 | |
| 4 | /* |
| 5 | * This assumes you have a 1.8432 MHz clock for your UART. |
| 6 | * |
| 7 | * It'd be nice if someone built a serial card with a 24.576 MHz |
| 8 | * clock, since the 16550A is capable of handling a top speed of 1.5 |
| 9 | * megabits/second; but this requires the faster clock. |
| 10 | */ |
| 11 | #define BASE_BAUD ( 1843200 / 16 ) |
| 12 | |
| 13 | /* Standard COM flags (except for COM4, because of the 8514 problem) */ |
| 14 | #ifdef CONFIG_SERIAL_DETECT_IRQ |
| 15 | #define STD_COM_FLAGS (ASYNC_BOOT_AUTOCONF | ASYNC_SKIP_TEST | ASYNC_AUTO_IRQ) |
| 16 | #define STD_COM4_FLAGS (ASYNC_BOOT_AUTOCONF | ASYNC_AUTO_IRQ) |
| Thomas Gleixner | 96a388d | 2007-10-11 11:20:03 +0200 | [diff] [blame] | 17 | #else |
| Roland Dreier | 217d115 | 2007-10-15 13:57:46 +0200 | [diff] [blame] | 18 | #define STD_COM_FLAGS (ASYNC_BOOT_AUTOCONF | ASYNC_SKIP_TEST) |
| 19 | #define STD_COM4_FLAGS ASYNC_BOOT_AUTOCONF |
| Thomas Gleixner | 96a388d | 2007-10-11 11:20:03 +0200 | [diff] [blame] | 20 | #endif |
| Roland Dreier | 217d115 | 2007-10-15 13:57:46 +0200 | [diff] [blame] | 21 | |
| 22 | #define SERIAL_PORT_DFNS \ |
| 23 | /* UART CLK PORT IRQ FLAGS */ \ |
| 24 | { 0, BASE_BAUD, 0x3F8, 4, STD_COM_FLAGS }, /* ttyS0 */ \ |
| 25 | { 0, BASE_BAUD, 0x2F8, 3, STD_COM_FLAGS }, /* ttyS1 */ \ |
| 26 | { 0, BASE_BAUD, 0x3E8, 4, STD_COM_FLAGS }, /* ttyS2 */ \ |
| 27 | { 0, BASE_BAUD, 0x2E8, 3, STD_COM4_FLAGS }, /* ttyS3 */ |
| 28 | |
| 29 | #endif /* _ASM_X86_SERIAL_H */ |