include/linux/usb/otg.h

/* USB OTG (On The Go) defines */
/*
 *
 * These APIs may be used between USB controllers.  USB device drivers
 * (for either host or peripheral roles) don't use these calls; they
 * continue to use just usb_device and usb_gadget.
 */

#ifndef __LINUX_USB_OTG_H
#define __LINUX_USB_OTG_H

#include <linux/notifier.h>

/* OTG defines lots of enumeration states before device reset */
enum usb_otg_state {
	OTG_STATE_UNDEFINED = 0,

	/* single-role peripheral, and dual-role default-b */
	OTG_STATE_B_IDLE,
	OTG_STATE_B_SRP_INIT,
	OTG_STATE_B_PERIPHERAL,

	/* extra dual-role default-b states */
	OTG_STATE_B_WAIT_ACON,
	OTG_STATE_B_HOST,

	/* dual-role default-a */
	OTG_STATE_A_IDLE,
	OTG_STATE_A_WAIT_VRISE,
	OTG_STATE_A_WAIT_BCON,
	OTG_STATE_A_HOST,
	OTG_STATE_A_SUSPEND,
	OTG_STATE_A_PERIPHERAL,
	OTG_STATE_A_WAIT_VFALL,
	OTG_STATE_A_VBUS_ERR,
};

enum usb_phy_events {
	USB_EVENT_NONE,         /* no events or cable disconnected */
	USB_EVENT_VBUS,         /* vbus valid event */
	USB_EVENT_ID,           /* id was grounded */
	USB_EVENT_CHARGER,      /* usb dedicated charger */
	USB_EVENT_ENUMERATED,   /* gadget driver enumerated */
};

struct usb_phy;

/* for transceivers connected thru an ULPI interface, the user must
 * provide access ops
 */
struct usb_phy_io_ops {
	int (*read)(struct usb_phy *x, u32 reg);
	int (*write)(struct usb_phy *x, u32 val, u32 reg);
};

struct usb_otg {
	u8			default_a;

	struct usb_phy		*phy;
	struct usb_bus		*host;
	struct usb_gadget	*gadget;

	/* bind/unbind the host controller */
	int	(*set_host)(struct usb_otg *otg, struct usb_bus *host);

	/* bind/unbind the peripheral controller */
	int	(*set_peripheral)(struct usb_otg *otg,
					struct usb_gadget *gadget);

	/* effective for A-peripheral, ignored for B devices */
	int	(*set_vbus)(struct usb_otg *otg, bool enabled);

	/* for B devices only:  start session with A-Host */
	int	(*start_srp)(struct usb_otg *otg);

	/* start or continue HNP role switch */
	int	(*start_hnp)(struct usb_otg *otg);

};

/*
 * the otg driver needs to interact with both device side and host side
 * usb controllers.  it decides which controller is active at a given
 * moment, using the transceiver, ID signal, HNP and sometimes static
 * configuration information (including "board isn't wired for otg").
 */
struct usb_phy {
	struct device		*dev;
	const char		*label;
	unsigned int		 flags;

	u8			default_a;
	enum usb_otg_state	state;
	enum usb_phy_events	last_event;

	struct usb_otg		*otg;

	struct usb_bus		*host;
	struct usb_gadget	*gadget;

	struct usb_phy_io_ops	*io_ops;
	void __iomem		*io_priv;

	/* for notification of usb_phy_events */
	struct atomic_notifier_head	notifier;

	/* to pass extra port status to the root hub */
	u16			port_status;
	u16			port_change;

	/* initialize/shutdown the OTG controller */
	int	(*init)(struct usb_phy *x);
	void	(*shutdown)(struct usb_phy *x);

	/* bind/unbind the host controller */
	int	(*set_host)(struct usb_phy *x,
				struct usb_bus *host);

	/* bind/unbind the peripheral controller */
	int	(*set_peripheral)(struct usb_phy *x,
				struct usb_gadget *gadget);

	/* effective for B devices, ignored for A-peripheral */
	int	(*set_power)(struct usb_phy *x,
				unsigned mA);

	/* effective for A-peripheral, ignored for B devices */
	int	(*set_vbus)(struct usb_phy *x,
				bool enabled);

	/* for non-OTG B devices: set transceiver into suspend mode */
	int	(*set_suspend)(struct usb_phy *x,
				int suspend);

	/* for B devices only:  start session with A-Host */
	int	(*start_srp)(struct usb_phy *x);

	/* start or continue HNP role switch */
	int	(*start_hnp)(struct usb_phy *x);

};


/* for board-specific init logic */
extern int usb_set_transceiver(struct usb_phy *);

#if defined(CONFIG_NOP_USB_XCEIV) || (defined(CONFIG_NOP_USB_XCEIV_MODULE) && defined(MODULE))
/* sometimes transceivers are accessed only through e.g. ULPI */
extern void usb_nop_xceiv_register(void);
extern void usb_nop_xceiv_unregister(void);
#else
static inline void usb_nop_xceiv_register(void)
{
}

static inline void usb_nop_xceiv_unregister(void)
{
}
#endif

/* helpers for direct access thru low-level io interface */
static inline int usb_phy_io_read(struct usb_phy *x, u32 reg)
{
	if (x->io_ops && x->io_ops->read)
		return x->io_ops->read(x, reg);

	return -EINVAL;
}

static inline int usb_phy_io_write(struct usb_phy *x, u32 val, u32 reg)
{
	if (x->io_ops && x->io_ops->write)
		return x->io_ops->write(x, val, reg);

	return -EINVAL;
}

static inline int
usb_phy_init(struct usb_phy *x)
{
	if (x->init)
		return x->init(x);

	return 0;
}

static inline void
usb_phy_shutdown(struct usb_phy *x)
{
	if (x->shutdown)
		x->shutdown(x);
}

/* for usb host and peripheral controller drivers */
#ifdef CONFIG_USB_OTG_UTILS
extern struct usb_phy *usb_get_transceiver(void);
extern void usb_put_transceiver(struct usb_phy *);
extern const char *otg_state_string(enum usb_otg_state state);
#else
static inline struct usb_phy *usb_get_transceiver(void)
{
	return NULL;
}

static inline void usb_put_transceiver(struct usb_phy *x)
{
}

static inline const char *otg_state_string(enum usb_otg_state state)
{
	return NULL;
}
#endif

/* Context: can sleep */
static inline int
otg_start_hnp(struct usb_phy *x)
{
	if (x->otg && x->otg->start_hnp)
		return x->otg->start_hnp(x->otg);

	return x->start_hnp(x);
}

/* Context: can sleep */
static inline int
otg_set_vbus(struct usb_phy *x, bool enabled)
{
	if (x->otg && x->otg->set_vbus)
		return x->otg->set_vbus(x->otg, enabled);

	return x->set_vbus(x, enabled);
}

/* for HCDs */
static inline int
otg_set_host(struct usb_phy *x, struct usb_bus *host)
{
	if (x->otg && x->otg->set_host)
		return x->otg->set_host(x->otg, host);

	return x->set_host(x, host);
}

/* for usb peripheral controller drivers */

/* Context: can sleep */
static inline int
otg_set_peripheral(struct usb_phy *x, struct usb_gadget *periph)
{
	if (x->otg && x->otg->set_peripheral)
		return x->otg->set_peripheral(x->otg, periph);

	return x->set_peripheral(x, periph);
}

static inline int
usb_phy_set_power(struct usb_phy *x, unsigned mA)
{
	if (x && x->set_power)
		return x->set_power(x, mA);
	return 0;
}

/* Context: can sleep */
static inline int
usb_phy_set_suspend(struct usb_phy *x, int suspend)
{
	if (x->set_suspend != NULL)
		return x->set_suspend(x, suspend);
	else
		return 0;
}

static inline int
otg_start_srp(struct usb_phy *x)
{
	if (x->otg && x->otg->start_srp)
		return x->otg->start_srp(x->otg);

	return x->start_srp(x);
}

/* notifiers */
static inline int
usb_register_notifier(struct usb_phy *x, struct notifier_block *nb)
{
	return atomic_notifier_chain_register(&x->notifier, nb);
}

static inline void
usb_unregister_notifier(struct usb_phy *x, struct notifier_block *nb)
{
	atomic_notifier_chain_unregister(&x->notifier, nb);
}

/* for OTG controller drivers (and maybe other stuff) */
extern int usb_bus_start_enum(struct usb_bus *bus, unsigned port_num);

/* Temporary aliases for transceiver functions */
#define otg_set_transceiver(x) usb_set_transceiver(x)
#define otg_get_transceiver() usb_get_transceiver()
#define otg_put_transceiver(x) usb_put_transceiver(x)

#define otg_io_read(x, a) usb_phy_io_read(x, a)
#define otg_io_write(x, a, b) usb_phy_io_write(x, a, b)

#define otg_init(x) usb_phy_init(x)
#define otg_shutdown(x) usb_phy_shutdown(x)
#define otg_set_power(x, a) usb_phy_set_power(x, a)
#define otg_set_suspend(x, a) usb_phy_set_suspend(x, a)

#define otg_register_notifier(x, a) usb_register_notifier(x, a)
#define otg_unregister_notifier(x, a) usb_unregiser_notifier(x, a)

#define otg_io_access_ops usb_phy_io_ops

#endif /* __LINUX_USB_OTG_H */