| David Fries | 6cd1597 | 2008-10-15 22:04:43 -0700 | [diff] [blame] | 1 | Kernel driver w1_therm | 
|  | 2 | ==================== | 
|  | 3 |  | 
|  | 4 | Supported chips: | 
|  | 5 | * Maxim ds18*20 based temperature sensors. | 
|  | 6 |  | 
|  | 7 | Author: Evgeniy Polyakov <johnpol@2ka.mipt.ru> | 
|  | 8 |  | 
|  | 9 |  | 
|  | 10 | Description | 
|  | 11 | ----------- | 
|  | 12 |  | 
|  | 13 | w1_therm provides basic temperature conversion for ds18*20 devices. | 
|  | 14 | supported family codes: | 
|  | 15 | W1_THERM_DS18S20	0x10 | 
|  | 16 | W1_THERM_DS1822		0x22 | 
|  | 17 | W1_THERM_DS18B20	0x28 | 
|  | 18 |  | 
|  | 19 | Support is provided through the sysfs w1_slave file.  Each open and | 
|  | 20 | read sequence will initiate a temperature conversion then provide two | 
|  | 21 | lines of ASCII output.  The first line contains the nine hex bytes | 
|  | 22 | read along with a calculated crc value and YES or NO if it matched. | 
|  | 23 | If the crc matched the returned values are retained.  The second line | 
|  | 24 | displays the retained values along with a temperature in millidegrees | 
|  | 25 | Centigrade after t=. | 
|  | 26 |  | 
|  | 27 | Parasite powered devices are limited to one slave performing a | 
|  | 28 | temperature conversion at a time.  If none of the devices are parasite | 
|  | 29 | powered it would be possible to convert all the devices at the same | 
|  | 30 | time and then go back to read individual sensors.  That isn't | 
|  | 31 | currently supported.  The driver also doesn't support reduced | 
|  | 32 | precision (which would also reduce the conversion time). | 
|  | 33 |  | 
|  | 34 | The module parameter strong_pullup can be set to 0 to disable the | 
|  | 35 | strong pullup or 1 to enable.  If enabled the 5V strong pullup will be | 
|  | 36 | enabled when the conversion is taking place provided the master driver | 
|  | 37 | must support the strong pullup (or it falls back to a pullup | 
|  | 38 | resistor).  The DS18b20 temperature sensor specification lists a | 
|  | 39 | maximum current draw of 1.5mA and that a 5k pullup resistor is not | 
|  | 40 | sufficient.  The strong pullup is designed to provide the additional | 
|  | 41 | current required. |