arch/cris/arch-v32/kernel/traps.c

/*
 * Copyright (C) 2003, Axis Communications AB.
 */

#include <linux/ptrace.h>
#include <asm/uaccess.h>

#include <asm/arch/hwregs/supp_reg.h>

extern void reset_watchdog(void);
extern void stop_watchdog(void);

extern int raw_printk(const char *fmt, ...);

void
show_registers(struct pt_regs *regs)
{
	/*
	 * It's possible to use either the USP register or current->thread.usp.
	 * USP might not correspond to the current proccess for all cases this
	 * function is called, and current->thread.usp isn't up to date for the
	 * current proccess. Experience shows that using USP is the way to go.
	 */
	unsigned long usp;
	unsigned long d_mmu_cause;
	unsigned long i_mmu_cause;

	usp = rdusp();

	raw_printk("CPU: %d\n", smp_processor_id());

	raw_printk("ERP: %08lx SRP: %08lx  CCS: %08lx USP: %08lx MOF: %08lx\n",
		regs->erp, regs->srp, regs->ccs, usp, regs->mof);

	raw_printk(" r0: %08lx  r1: %08lx   r2: %08lx  r3: %08lx\n",
		regs->r0, regs->r1, regs->r2, regs->r3);

	raw_printk(" r4: %08lx  r5: %08lx   r6: %08lx  r7: %08lx\n",
		regs->r4, regs->r5, regs->r6, regs->r7);

	raw_printk(" r8: %08lx  r9: %08lx  r10: %08lx r11: %08lx\n",
		regs->r8, regs->r9, regs->r10, regs->r11);

	raw_printk("r12: %08lx r13: %08lx oR10: %08lx acr: %08lx\n",
		regs->r12, regs->r13, regs->orig_r10, regs->acr);

	raw_printk("sp: %08lx\n", regs);

	SUPP_BANK_SEL(BANK_IM);
	SUPP_REG_RD(RW_MM_CAUSE, i_mmu_cause);

	SUPP_BANK_SEL(BANK_DM);
	SUPP_REG_RD(RW_MM_CAUSE, d_mmu_cause);

	raw_printk("       Data MMU Cause: %08lx\n", d_mmu_cause);
	raw_printk("Instruction MMU Cause: %08lx\n", i_mmu_cause);

	raw_printk("Process %s (pid: %d, stackpage: %08lx)\n",
		current->comm, current->pid, (unsigned long) current);

	/* Show additional info if in kernel-mode. */
	if (!user_mode(regs)) {
		int i;
		unsigned char c;

		show_stack(NULL, (unsigned long *) usp);

		/*
		 * If the previous stack-dump wasn't a kernel one, dump the
		 * kernel stack now.
		 */
		if (usp != 0)
			show_stack(NULL, NULL);

		raw_printk("\nCode: ");

		if (regs->erp < PAGE_OFFSET)
			goto bad_value;

		/*
		 * Quite often the value at regs->erp doesn't point to the
		 * interesting instruction, which often is the previous
		 * instruction. So dump at an offset large enough that the
		 * instruction decoding should be in sync at the interesting
		 * point, but small enough to fit on a row. The regs->erp
		 * location is pointed out in a ksymoops-friendly way by
		 * wrapping the byte for that address in parenthesis.
		 */
		for (i = -12; i < 12; i++) {
			if (__get_user(c, &((unsigned char *) regs->erp)[i])) {
bad_value:
				raw_printk(" Bad IP value.");
				break;
			}

			if (i == 0)
				raw_printk("(%02x) ", c);
			else
				raw_printk("%02x ", c);
		}

		raw_printk("\n");
	}
}

/*
 * This gets called from entry.S when the watchdog has bitten. Show something
 * similiar to an Oops dump, and if the kernel if configured to be a nice doggy;
 * halt instead of reboot.
 */
void
watchdog_bite_hook(struct pt_regs *regs)
{
#ifdef CONFIG_ETRAX_WATCHDOG_NICE_DOGGY
	local_irq_disable();
	stop_watchdog();
	show_registers(regs);

	while (1)
		; /* Do nothing. */
#else
	show_registers(regs);
#endif
}

/* This is normally the Oops function. */
void
die_if_kernel(const char *str, struct pt_regs *regs, long err)
{
	if (user_mode(regs))
		return;

#ifdef CONFIG_ETRAX_WATCHDOG_NICE_DOGGY
	/*
	 * This printout might take too long and could trigger
	 * the watchdog normally. If NICE_DOGGY is set, simply
	 * stop the watchdog during the printout.
	 */
	stop_watchdog();
#endif

	raw_printk("%s: %04lx\n", str, err & 0xffff);

	show_registers(regs);

#ifdef CONFIG_ETRAX_WATCHDOG_NICE_DOGGY
	reset_watchdog();
#endif

	do_exit(SIGSEGV);
}

void arch_enable_nmi(void)
{
	unsigned long flags;
	local_save_flags(flags);
	flags |= (1<<30); /* NMI M flag is at bit 30 */
	local_irq_restore(flags);
}