Linux-2.6.12-rc2
Initial git repository build. I'm not bothering with the full history,
even though we have it. We can create a separate "historical" git
archive of that later if we want to, and in the meantime it's about
3.2GB when imported into git - space that would just make the early
git days unnecessarily complicated, when we don't have a lot of good
infrastructure for it.
Let it rip!
diff --git a/drivers/scsi/qla2xxx/qla_settings.h b/drivers/scsi/qla2xxx/qla_settings.h
new file mode 100644
index 0000000..c58f5fa
--- /dev/null
+++ b/drivers/scsi/qla2xxx/qla_settings.h
@@ -0,0 +1,64 @@
+/******************************************************************************
+ * QLOGIC LINUX SOFTWARE
+ *
+ * QLogic ISP2x00 device driver for Linux 2.6.x
+ * Copyright (C) 2003-2004 QLogic Corporation
+ * (www.qlogic.com)
+ *
+ * This program is free software; you can redistribute it and/or modify it
+ * under the terms of the GNU General Public License as published by the
+ * Free Software Foundation; either version 2, or (at your option) any
+ * later version.
+ *
+ * This program is distributed in the hope that it will be useful, but
+ * WITHOUT ANY WARRANTY; without even the implied warranty of
+ * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the GNU
+ * General Public License for more details.
+ *
+ ******************************************************************************/
+/*
+ * Compile time Options:
+ * 0 - Disable and 1 - Enable
+ */
+#define DEBUG_QLA2100 0 /* For Debug of qla2x00 */
+
+#define STOP_ON_RESET 0
+#define USE_ABORT_TGT 1 /* Use Abort Target mbx cmd */
+
+#define VSA 0 /* Volume Set Addressing */
+
+/* Failover options */
+#define MAX_RECOVERYTIME 10 /*
+ * Max suspend time for a lun recovery
+ * time
+ */
+#define MAX_FAILBACKTIME 5 /* Max suspend time before fail back */
+
+#define QLA_CMD_TIMER_DELTA 3
+
+/*
+ * When a lun is suspended for the "Not Ready" condition then it will suspend
+ * the lun for increments of 6 sec delays. SUSPEND_COUNT is that count.
+ */
+#define SUSPEND_COUNT 10 /* 6 secs * 10 retries = 60 secs */
+
+/*
+ * Defines the time in seconds that the driver extends the command timeout to
+ * get around the problem where the mid-layer only allows 5 retries for
+ * commands that return BUS_BUSY
+ */
+#define EXTEND_CMD_TIMEOUT 60
+
+#define MAX_RETRIES_OF_ISP_ABORT 5
+
+/* Max time to wait for the loop to be in LOOP_READY state */
+#define MAX_LOOP_TIMEOUT (60 * 5)
+#define EH_ACTIVE 1 /* Error handler active */
+
+/*
+ * Some vendor subsystems do not recover properly after a device reset. Define
+ * the following to force a logout after a successful device reset.
+ */
+#undef LOGOUT_AFTER_DEVICE_RESET
+
+#include "qla_version.h"