[PATCH] ide: housekeeping on IDE drivers
Move auto arrays to static (const). Clean up using PCI_DEVICE in places,
remove unreachable junk and dead code.
Fix the serverworks cable detect logic (if ordering is wrong). Backport
from libata. Plenty of scope for more cleanup left.
Signed-off-by: Alan Cox <alan@redhat.com>
Cc: Bartlomiej Zolnierkiewicz <B.Zolnierkiewicz@elka.pw.edu.pl>
Cc: Sergei Shtylyov <sshtylyov@ru.mvista.com>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
diff --git a/drivers/ide/pci/slc90e66.c b/drivers/ide/pci/slc90e66.c
index 5112c72..0968f6b 100644
--- a/drivers/ide/pci/slc90e66.c
+++ b/drivers/ide/pci/slc90e66.c
@@ -72,7 +72,8 @@
u16 master_data;
u8 slave_data;
/* ISP RTC */
- u8 timings[][2] = { { 0, 0 },
+ static const u8 timings[][2]= {
+ { 0, 0 },
{ 0, 0 },
{ 1, 0 },
{ 2, 1 },
@@ -119,7 +120,6 @@
pci_read_config_word(dev, 0x4a, ®4a);
switch(speed) {
-#ifdef CONFIG_BLK_DEV_IDEDMA
case XFER_UDMA_4: u_speed = 4 << (drive->dn * 4); break;
case XFER_UDMA_3: u_speed = 3 << (drive->dn * 4); break;
case XFER_UDMA_2: u_speed = 2 << (drive->dn * 4); break;
@@ -128,7 +128,6 @@
case XFER_MW_DMA_2:
case XFER_MW_DMA_1:
case XFER_SW_DMA_2: break;
-#endif /* CONFIG_BLK_DEV_IDEDMA */
case XFER_PIO_4:
case XFER_PIO_3:
case XFER_PIO_2:
@@ -156,7 +155,6 @@
return (ide_config_drive_speed(drive, speed));
}
-#ifdef CONFIG_BLK_DEV_IDEDMA
static int slc90e66_config_drive_for_dma (ide_drive_t *drive)
{
u8 speed = ide_dma_speed(drive, slc90e66_ratemask(drive));
@@ -194,7 +192,6 @@
/* IORDY not supported */
return 0;
}
-#endif /* CONFIG_BLK_DEV_IDEDMA */
static void __devinit init_hwif_slc90e66 (ide_hwif_t *hwif)
{
@@ -222,7 +219,6 @@
hwif->mwdma_mask = 0x07;
hwif->swdma_mask = 0x07;
-#ifdef CONFIG_BLK_DEV_IDEDMA
if (!(hwif->udma_four))
/* bit[0(1)]: 0:80, 1:40 */
hwif->udma_four = (reg47 & mask) ? 0 : 1;
@@ -232,7 +228,6 @@
hwif->autodma = 1;
hwif->drives[0].autodma = hwif->autodma;
hwif->drives[1].autodma = hwif->autodma;
-#endif /* !CONFIG_BLK_DEV_IDEDMA */
}
static ide_pci_device_t slc90e66_chipset __devinitdata = {
@@ -250,7 +245,7 @@
}
static struct pci_device_id slc90e66_pci_tbl[] = {
- { PCI_VENDOR_ID_EFAR, PCI_DEVICE_ID_EFAR_SLC90E66_1, PCI_ANY_ID, PCI_ANY_ID, 0, 0, 0},
+ { PCI_DEVICE(PCI_VENDOR_ID_EFAR, PCI_DEVICE_ID_EFAR_SLC90E66_1), 0},
{ 0, },
};
MODULE_DEVICE_TABLE(pci, slc90e66_pci_tbl);