usb: musb: drop useless board_mode usage
we are compiling the driver always with full OTG
capabilities, so that board_mode trick becomes
useless.
Signed-off-by: Felipe Balbi <balbi@ti.com>
diff --git a/drivers/usb/musb/omap2430.c b/drivers/usb/musb/omap2430.c
index 392fc7a..e32aff9 100644
--- a/drivers/usb/musb/omap2430.c
+++ b/drivers/usb/musb/omap2430.c
@@ -258,7 +258,7 @@
otg->default_a = true;
musb->xceiv->state = OTG_STATE_A_IDLE;
musb->xceiv->last_event = USB_EVENT_ID;
- if (!is_otg_enabled(musb) || musb->gadget_driver) {
+ if (musb->gadget_driver) {
pm_runtime_get_sync(dev);
usb_phy_init(musb->xceiv);
omap2430_musb_set_vbus(musb, 1);
@@ -281,11 +281,10 @@
dev_dbg(dev, "VBUS Disconnect\n");
musb->xceiv->last_event = USB_EVENT_NONE;
- if (is_otg_enabled(musb) || is_peripheral_enabled(musb))
- if (musb->gadget_driver) {
- pm_runtime_mark_last_busy(dev);
- pm_runtime_put_autosuspend(dev);
- }
+ if (musb->gadget_driver) {
+ pm_runtime_mark_last_busy(dev);
+ pm_runtime_put_autosuspend(dev);
+ }
if (data->interface_type == MUSB_INTERFACE_UTMI) {
if (musb->xceiv->otg->set_vbus)