isci: add support for 2 more oem parmeters
1/ add OEM paramater support for mode_type (MPC vs APC)
2/ add OEM parameter support for max_number_concurrent_device_spin_up
3/ cleanup scic_sds_controller_start_next_phy
todo: hook up the amp control afe parameters into the afe init code
Signed-off-by: Henryk Dembkowski <henryk.dembkowski@intel.com>
Signed-off-by: Jacek Danecki <Jacek.Danecki@intel.com>
[cleaned up scic_sds_controller_start_next_phy]
Signed-off-by: Dan Williams <dan.j.williams@intel.com>
diff --git a/drivers/scsi/isci/probe_roms.h b/drivers/scsi/isci/probe_roms.h
index 96d8b92..69526ff 100644
--- a/drivers/scsi/isci/probe_roms.h
+++ b/drivers/scsi/isci/probe_roms.h
@@ -86,6 +86,20 @@
#define ISCI_EFI_ATTRIBUTES 0
#define ISCI_EFI_VAR_NAME "isci_oemb"
+/* Allowed PORT configuration modes APC Automatic PORT configuration mode is
+ * defined by the OEM configuration parameters providing no PHY_MASK parameters
+ * for any PORT. i.e. There are no phys assigned to any of the ports at start.
+ * MPC Manual PORT configuration mode is defined by the OEM configuration
+ * parameters providing a PHY_MASK value for any PORT. It is assumed that any
+ * PORT with no PHY_MASK is an invalid port and not all PHYs must be assigned.
+ * A PORT_PHY mask that assigns just a single PHY to a port and no other PHYs
+ * being assigned is sufficient to declare manual PORT configuration.
+ */
+enum SCIC_PORT_CONFIGURATION_MODE {
+ SCIC_PORT_MANUAL_CONFIGURATION_MODE = 0,
+ SCIC_PORT_AUTOMATIC_CONFIGURATION_MODE = 1
+};
+
struct sci_bios_oem_param_block_hdr {
uint8_t signature[ISCI_ROM_SIG_SIZE];
uint16_t total_block_length;