Fix misc .c/.h comment typos
Fix various .c/.h typos in comments (no code changes).
Signed-off-by: Matt LaPlante <kernel1@cyberdogtech.com>
Signed-off-by: Adrian Bunk <bunk@stusta.de>
diff --git a/drivers/char/rio/riocmd.c b/drivers/char/rio/riocmd.c
index 4df6ab2..167ebc8 100644
--- a/drivers/char/rio/riocmd.c
+++ b/drivers/char/rio/riocmd.c
@@ -922,7 +922,7 @@
**
** Packet is an actual packet structure to be filled in with the packet
** information associated with the command. You need to fill in everything,
-** as the command processore doesn't process the command packet in any way.
+** as the command processor doesn't process the command packet in any way.
**
** The PreFuncP is called before the packet is enqueued on the host rup.
** PreFuncP is called as (*PreFuncP)(PreArg, CmdBlkP);. PreFuncP must
diff --git a/drivers/char/rio/rioinit.c b/drivers/char/rio/rioinit.c
index 99f3df0..0794844 100644
--- a/drivers/char/rio/rioinit.c
+++ b/drivers/char/rio/rioinit.c
@@ -222,7 +222,7 @@
** which value will be written into memory.
** Call with op set to zero means that the RAM will not be read and checked
** before it is written.
-** Call with op not zero, and the RAM will be read and compated with val[op-1]
+** Call with op not zero and the RAM will be read and compared with val[op-1]
** to check that the data from the previous phase was retained.
*/
diff --git a/drivers/char/rio/rioparam.c b/drivers/char/rio/rioparam.c
index 1066d97..bb498d2 100644
--- a/drivers/char/rio/rioparam.c
+++ b/drivers/char/rio/rioparam.c
@@ -87,8 +87,8 @@
** command bit set onto the port. The command bit is in the len field,
** and gets ORed in with the actual byte count.
**
-** When you send a packet with the command bit set, then the first
-** data byte ( data[0] ) is interpretted as the command to execute.
+** When you send a packet with the command bit set the first
+** data byte (data[0]) is interpreted as the command to execute.
** It also governs what data structure overlay should accompany the packet.
** Commands are defined in cirrus/cirrus.h
**
@@ -103,7 +103,7 @@
**
** Most commands do not use the remaining bytes in the data array. The
** exceptions are OPEN MOPEN and CONFIG. (NB. As with the SI CONFIG and
-** OPEN are currently analagous). With these three commands the following
+** OPEN are currently analogous). With these three commands the following
** 11 data bytes are all used to pass config information such as baud rate etc.
** The fields are also defined in cirrus.h. Some contain straightforward
** information such as the transmit XON character. Two contain the transmit and