[ARM] ohci-pxa27x: introduce flags to avoid direct access to OHCI registers
Direct access to USB host controller registers is considered to be not
portable, and is usually a bad sign for poorly abstracted interface.
Introduce .flags and .power_on_delay to "struct pxaohci_platform_data"
so that most platforms don't bother to write their own .init/.exit()
sequences.
Signed-off-by: Eric Miao <eric.miao@marvell.com>
Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>
diff --git a/arch/arm/mach-pxa/cm-x270.c b/arch/arm/mach-pxa/cm-x270.c
index 102a431..a82dad1 100644
--- a/arch/arm/mach-pxa/cm-x270.c
+++ b/arch/arm/mach-pxa/cm-x270.c
@@ -257,18 +257,9 @@
/* PXA27x OHCI controller setup */
#if defined(CONFIG_USB_OHCI_HCD) || defined(CONFIG_USB_OHCI_HCD_MODULE)
-static int cmx270_ohci_init(struct device *dev)
-{
- /* Set the Power Control Polarity Low */
- UHCHR = (UHCHR | UHCHR_PCPL) &
- ~(UHCHR_SSEP1 | UHCHR_SSEP2 | UHCHR_SSE);
-
- return 0;
-}
-
static struct pxaohci_platform_data cmx270_ohci_platform_data = {
.port_mode = PMM_PERPORT_MODE,
- .init = cmx270_ohci_init,
+ .flags = ENABLE_PORT1 | ENABLE_PORT2 | POWER_CONTROL_LOW,
};
static void __init cmx270_init_ohci(void)