HID: split picolcd's operation_mode sysfs attribute
Original operation_mode sysfs attribute accepts the operation mode
as main value with an option delay as second value to change
the start-up delay on mode change.
As it is preferred to have exactly one value per sysfs attribute,
extract this delay into a separate sysfs attribute called
operation_mode_delay.
Signed-off-by: Bruno Prémont <bonbons@linux-vserver.org>
Signed-off-by: Jiri Kosina <jkosina@suse.cz>
diff --git a/Documentation/ABI/testing/sysfs-driver-hid-picolcd b/Documentation/ABI/testing/sysfs-driver-hid-picolcd
index 14f52d7..08579e7 100644
--- a/Documentation/ABI/testing/sysfs-driver-hid-picolcd
+++ b/Documentation/ABI/testing/sysfs-driver-hid-picolcd
@@ -8,12 +8,21 @@
enclosed in brackets ('[' and ']')
Writing: causes operation mode switch. Permitted values are
- the non-active mode names listed when read, optionally followed
- by a delay value expressed in ms.
+ the non-active mode names listed when read.
Note: when switching mode the current PicoLCD HID device gets
- disconnected and reconnects after above delay (default value
- is 5 seconds though this default should not be relied on).
+ disconnected and reconnects after above delay (see attribute
+ operation_mode_delay for its value).
+
+
+What: /sys/bus/usb/devices/<busnum>-<devnum>:<config num>.<interface num>/<hid-bus>:<vendor-id>:<product-id>.<num>/operation_mode_delay
+Date: April 2010
+Contact: Bruno Prémont <bonbons@linux-vserver.org>
+Description: Delay PicoLCD waits before restarting in new mode when
+ operation_mode has changed.
+
+ Reading/Writing: It is expressed in ms and permitted range is
+ 0..30000ms.
What: /sys/bus/usb/devices/<busnum>-<devnum>:<config num>.<interface num>/<hid-bus>:<vendor-id>:<product-id>.<num>/fb_update_rate