libata: convert to iomap
Convert libata core layer and LLDs to use iomap.
* managed iomap is used. Pointer to pcim_iomap_table() is cached at
host->iomap and used through out LLDs. This basically replaces
host->mmio_base.
* if possible, pcim_iomap_regions() is used
Most iomap operation conversions are taken from Jeff Garzik
<jgarzik@pobox.com>'s iomap branch.
Signed-off-by: Tejun Heo <htejun@gmail.com>
Signed-off-by: Jeff Garzik <jeff@garzik.org>
diff --git a/drivers/ata/ata_generic.c b/drivers/ata/ata_generic.c
index a25cbd6..c79887f 100644
--- a/drivers/ata/ata_generic.c
+++ b/drivers/ata/ata_generic.c
@@ -79,7 +79,7 @@
/* Bits 5 and 6 indicate if DMA is active on master/slave */
if (ap->ioaddr.bmdma_addr)
- dma_enabled = inb(ap->ioaddr.bmdma_addr + ATA_DMA_CMD);
+ dma_enabled = ioread8(ap->ioaddr.bmdma_addr + ATA_DMA_CMD);
for (i = 0; i < ATA_MAX_DEVICES; i++) {
struct ata_device *dev = &ap->device[i];
@@ -138,7 +138,7 @@
.bmdma_stop = ata_bmdma_stop,
.bmdma_status = ata_bmdma_status,
- .data_xfer = ata_pio_data_xfer,
+ .data_xfer = ata_data_xfer,
.freeze = ata_bmdma_freeze,
.thaw = ata_bmdma_thaw,