ixgb: convert to net_device_ops
Convert this driver to network device ops. Compile tested only.
Signed-off-by: Stephen Hemminger <shemminger@vyatta.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ixgbe/ixgbe_main.c b/drivers/net/ixgbe/ixgbe_main.c
index d1f80dd..6fb8738 100644
--- a/drivers/net/ixgbe/ixgbe_main.c
+++ b/drivers/net/ixgbe/ixgbe_main.c
@@ -3727,6 +3727,23 @@
return hw->mac.ops.setup_link_speed(hw, autoneg, true, true);
}
+static const struct net_device_ops ixgbe_netdev_ops = {
+ .ndo_open = ixgbe_open,
+ .ndo_stop = ixgbe_close,
+ .ndo_get_stats = ixgbe_get_stats,
+ .ndo_set_multicast_list = ixgbe_set_rx_mode,
+ .ndo_validate_addr = eth_validate_addr,
+ .ndo_set_mac_address = ixgbe_set_mac,
+ .ndo_change_mtu = ixgbe_change_mtu,
+ .ndo_tx_timeout = ixgbe_tx_timeout,
+ .ndo_vlan_rx_register = ixgbe_vlan_rx_register,
+ .ndo_vlan_rx_add_vid = ixgbe_vlan_rx_add_vid,
+ .ndo_vlan_rx_kill_vid = ixgbe_vlan_rx_kill_vid,
+#ifdef CONFIG_NET_POLL_CONTROLLER
+ .ndo_poll_controller = ixgbe_netpoll,
+#endif
+};
+
/**
* ixgbe_probe - Device Initialization Routine
* @pdev: PCI device information struct
@@ -3808,23 +3825,10 @@
continue;
}
- netdev->open = &ixgbe_open;
- netdev->stop = &ixgbe_close;
+ netdev->netdev_ops = &ixgbe_netdev_ops;
netdev->hard_start_xmit = &ixgbe_xmit_frame;
- netdev->get_stats = &ixgbe_get_stats;
- netdev->set_rx_mode = &ixgbe_set_rx_mode;
- netdev->set_multicast_list = &ixgbe_set_rx_mode;
- netdev->set_mac_address = &ixgbe_set_mac;
- netdev->change_mtu = &ixgbe_change_mtu;
ixgbe_set_ethtool_ops(netdev);
- netdev->tx_timeout = &ixgbe_tx_timeout;
netdev->watchdog_timeo = 5 * HZ;
- netdev->vlan_rx_register = ixgbe_vlan_rx_register;
- netdev->vlan_rx_add_vid = ixgbe_vlan_rx_add_vid;
- netdev->vlan_rx_kill_vid = ixgbe_vlan_rx_kill_vid;
-#ifdef CONFIG_NET_POLL_CONTROLLER
- netdev->poll_controller = ixgbe_netpoll;
-#endif
strcpy(netdev->name, pci_name(pdev));
adapter->bd_number = cards_found;