USB: ohci-pxa27x: add DT bindings
Add DT bindings to the ohci-pxa27x driver and some documentation.
Successfully tested on a PXA3xx board.
Signed-off-by: Daniel Mack <zonque@gmail.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
diff --git a/Documentation/devicetree/bindings/usb/pxa-usb.txt b/Documentation/devicetree/bindings/usb/pxa-usb.txt
new file mode 100644
index 0000000..79729a9
--- /dev/null
+++ b/Documentation/devicetree/bindings/usb/pxa-usb.txt
@@ -0,0 +1,31 @@
+PXA USB controllers
+
+OHCI
+
+Required properties:
+ - compatible: Should be "marvell,pxa-ohci" for USB controllers
+ used in host mode.
+
+Optional properties:
+ - "marvell,enable-port1", "marvell,enable-port2", "marvell,enable-port3"
+ If present, enables the appropriate USB port of the controller.
+ - "marvell,port-mode" selects the mode of the ports:
+ 1 = PMM_NPS_MODE
+ 2 = PMM_GLOBAL_MODE
+ 3 = PMM_PERPORT_MODE
+ - "marvell,power-sense-low" - power sense pin is low-active.
+ - "marvell,power-control-low" - power control pin is low-active.
+ - "marvell,no-oc-protection" - disable over-current protection.
+ - "marvell,oc-mode-perport" - enable per-port over-current protection.
+ - "marvell,power_on_delay" Power On to Power Good time - in ms.
+
+Example:
+
+ usb0: ohci@4c000000 {
+ compatible = "marvell,pxa-ohci", "usb-ohci";
+ reg = <0x4c000000 0x100000>;
+ interrupts = <18>;
+ marvell,enable-port1;
+ marvell,port-mode = <2>; /* PMM_GLOBAL_MODE */
+ };
+