ehci: enable debugging code when CONFIG_DYNAMIC_DEBUG is set
The debugging code for ehci is enabled to run if the DEBUG flag is defined.
This patch enables the debugging code also when the kernel is configured
with dynamic debugging on.
Signed-off-by: Xenia Ragiadakou <burzalodowa@gmail.com>
Signed-off-by: Alan Stern <stern@rowland.harvard.edu>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
diff --git a/drivers/usb/host/ehci-fsl.c b/drivers/usb/host/ehci-fsl.c
index e44f442..947b009 100644
--- a/drivers/usb/host/ehci-fsl.c
+++ b/drivers/usb/host/ehci-fsl.c
@@ -418,7 +418,7 @@
struct fsl_usb2_platform_data *pdata = dev_get_platdata(dev);
u32 tmp;
-#ifdef DEBUG
+#if defined(DEBUG) || defined(CONFIG_DYNAMIC_DEBUG)
u32 mode = ehci_readl(ehci, hcd->regs + FSL_SOC_USB_USBMODE);
mode &= USBMODE_CM_MASK;
tmp = ehci_readl(ehci, hcd->regs + 0x140); /* usbcmd */