sfc: SFT9001/SFN4111T: Check PHY boot status during board initialisation
During SFN4111T initialisation, check whether the PHY boot status
indicates a bad firmware checksum. If so, prepare to reflash rather
than continuing with normal initialisation.
Remove redundant PHY boot status check from tenxpress_phy_init().
Signed-off-by: Ben Hutchings <bhutchings@solarflare.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/sfc/sfe4001.c b/drivers/net/sfc/sfe4001.c
index c0e9068..4eac5da 100644
--- a/drivers/net/sfc/sfe4001.c
+++ b/drivers/net/sfc/sfe4001.c
@@ -399,6 +399,7 @@
int sfn4111t_init(struct efx_nic *efx)
{
+ int i = 0;
int rc;
efx->board_info.hwmon_client =
@@ -417,13 +418,20 @@
if (rc)
goto fail_hwmon;
- if (efx->phy_mode & PHY_MODE_SPECIAL) {
- efx_stats_disable(efx);
- sfn4111t_reset(efx);
- }
+ do {
+ if (efx->phy_mode & PHY_MODE_SPECIAL) {
+ /* PHY may not generate a 156.25 MHz clock and MAC
+ * stats fetch will fail. */
+ efx_stats_disable(efx);
+ sfn4111t_reset(efx);
+ }
+ rc = sft9001_wait_boot(efx);
+ if (rc == 0)
+ return 0;
+ efx->phy_mode = PHY_MODE_SPECIAL;
+ } while (rc == -EINVAL && ++i < 2);
- return 0;
-
+ device_remove_file(&efx->pci_dev->dev, &dev_attr_phy_flash_cfg);
fail_hwmon:
i2c_unregister_device(efx->board_info.hwmon_client);
return rc;