USB: remove use of err() in drivers/usb/serial
err() is going away, so switch to dev_err() or printk() if it's really
needed.
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
diff --git a/drivers/usb/serial/cypress_m8.c b/drivers/usb/serial/cypress_m8.c
index e0ca809..eae4740 100644
--- a/drivers/usb/serial/cypress_m8.c
+++ b/drivers/usb/serial/cypress_m8.c
@@ -404,8 +404,8 @@
retval != -ENODEV);
if (retval != sizeof(feature_buffer)) {
- err("%s - failed sending serial line settings - %d",
- __func__, retval);
+ dev_err(&port->dev, "%s - failed sending serial "
+ "line settings - %d\n", __func__, retval);
cypress_set_dead(port);
} else {
spin_lock_irqsave(&priv->lock, flags);
@@ -443,7 +443,8 @@
&& retval != -ENODEV);
if (retval != sizeof(feature_buffer)) {
- err("%s - failed to retrieve serial line settings - %d", __func__, retval);
+ dev_err(&port->dev, "%s - failed to retrieve serial "
+ "line settings - %d\n", __func__, retval);
cypress_set_dead(port);
return retval;
} else {
@@ -476,8 +477,8 @@
priv->comm_is_ok = 0;
spin_unlock_irqrestore(&priv->lock, flags);
- err("cypress_m8 suspending failing port %d - interval might be too short",
- port->number);
+ dev_err(&port->dev, "cypress_m8 suspending failing port %d - "
+ "interval might be too short\n", port->number);
}
@@ -679,7 +680,8 @@
/* setup the port and start reading from the device */
if (!port->interrupt_in_urb) {
- err("%s - interrupt_in_urb is empty!", __func__);
+ dev_err(&port->dev, "%s - interrupt_in_urb is empty!\n",
+ __func__);
return -1;
}
@@ -1107,8 +1109,8 @@
data_bits = 3;
break;
default:
- err("%s - CSIZE was set, but not CS5-CS8",
- __func__);
+ dev_err(&port->dev, "%s - CSIZE was set, but not CS5-CS8\n",
+ __func__);
data_bits = 3;
}
spin_lock_irqsave(&priv->lock, flags);