mmc: Test bus-width for old MMC devices
Some old MMC devices fail with the 4/8 bits the driver tries to use
exclusively. This patch adds a test for the given bus setup and falls
back to the lower bit mode (until 1-bit mode) when the test fails.
[Major rework and refactoring by tiwai]
[Quirk addition and many fixes by prakity]
Signed-off-by: Aries Lee <arieslee@jmicron.com>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Signed-off-by: Philip Rakity <prakity@marvell.com>
Tested-by: Philip Rakity <prakity@marvell.com>
Signed-off-by: Chris Ball <cjb@laptop.org>
diff --git a/drivers/mmc/host/sdhci.c b/drivers/mmc/host/sdhci.c
index 5569886..d5febe5 100644
--- a/drivers/mmc/host/sdhci.c
+++ b/drivers/mmc/host/sdhci.c
@@ -23,6 +23,7 @@
#include <linux/leds.h>
+#include <linux/mmc/mmc.h>
#include <linux/mmc/host.h>
#include "sdhci.h"
@@ -1521,7 +1522,11 @@
if (intmask & SDHCI_INT_DATA_TIMEOUT)
host->data->error = -ETIMEDOUT;
- else if (intmask & (SDHCI_INT_DATA_CRC | SDHCI_INT_DATA_END_BIT))
+ else if (intmask & SDHCI_INT_DATA_END_BIT)
+ host->data->error = -EILSEQ;
+ else if ((intmask & SDHCI_INT_DATA_CRC) &&
+ SDHCI_GET_CMD(sdhci_readw(host, SDHCI_COMMAND))
+ != MMC_BUS_TEST_R)
host->data->error = -EILSEQ;
else if (intmask & SDHCI_INT_ADMA_ERROR) {
printk(KERN_ERR "%s: ADMA error\n", mmc_hostname(host->mmc));
diff --git a/drivers/mmc/host/sdhci.h b/drivers/mmc/host/sdhci.h
index 1efe7dc..6e0969e 100644
--- a/drivers/mmc/host/sdhci.h
+++ b/drivers/mmc/host/sdhci.h
@@ -52,6 +52,7 @@
#define SDHCI_CMD_RESP_SHORT_BUSY 0x03
#define SDHCI_MAKE_CMD(c, f) (((c & 0xff) << 8) | (f & 0xff))
+#define SDHCI_GET_CMD(c) ((c>>8) & 0x3f)
#define SDHCI_RESPONSE 0x10