eeepc: Use pr_warn
Just a trivial pr_warning to pr_warn conversion
while adding a few missing newlines.
Signed-off-by: Joe Perches <joe@perches.com>
Signed-off-by: Matthew Garrett <mjg@redhat.com>
diff --git a/drivers/platform/x86/eeepc-laptop.c b/drivers/platform/x86/eeepc-laptop.c
index 2c1abf6..1c45d92 100644
--- a/drivers/platform/x86/eeepc-laptop.c
+++ b/drivers/platform/x86/eeepc-laptop.c
@@ -228,7 +228,7 @@
return -ENODEV;
if (write_acpi_int(eeepc->handle, method, value))
- pr_warning("Error writing %s\n", method);
+ pr_warn("Error writing %s\n", method);
return 0;
}
@@ -243,7 +243,7 @@
return -ENODEV;
if (read_acpi_int(eeepc->handle, method, &value))
- pr_warning("Error reading %s\n", method);
+ pr_warn("Error reading %s\n", method);
return value;
}
@@ -261,7 +261,7 @@
status = acpi_get_handle(eeepc->handle, (char *)method,
handle);
if (status != AE_OK) {
- pr_warning("Error finding %s\n", method);
+ pr_warn("Error finding %s\n", method);
return -ENODEV;
}
return 0;
@@ -417,7 +417,7 @@
switch (value) {
case 0:
if (eeepc->cpufv_disabled)
- pr_warning("cpufv enabled (not officially supported "
+ pr_warn("cpufv enabled (not officially supported "
"on this model)\n");
eeepc->cpufv_disabled = false;
return rv;
@@ -609,7 +609,7 @@
bus = port->subordinate;
if (!bus) {
- pr_warning("Unable to find PCI bus?\n");
+ pr_warn("Unable to find PCI bus 1?\n");
goto out_unlock;
}
@@ -621,12 +621,12 @@
absent = (l == 0xffffffff);
if (blocked != absent) {
- pr_warning("BIOS says wireless lan is %s, "
- "but the pci device is %s\n",
+ pr_warn("BIOS says wireless lan is %s, "
+ "but the pci device is %s\n",
blocked ? "blocked" : "unblocked",
absent ? "absent" : "present");
- pr_warning("skipped wireless hotplug as probably "
- "inappropriate for this model\n");
+ pr_warn("skipped wireless hotplug as probably "
+ "inappropriate for this model\n");
goto out_unlock;
}
@@ -691,7 +691,8 @@
eeepc_rfkill_notify,
eeepc);
if (ACPI_FAILURE(status))
- pr_warning("Failed to register notify on %s\n", node);
+ pr_warn("Failed to register notify on %s\n", node);
+
/*
* Refresh pci hotplug in case the rfkill state was
* changed during setup.