powerpc/booke: Clean up the hardware watchpoint support
* CONFIG_BOOKE is selected by CONFIG_44x so we dont need both
* Fixed a few comments
* Go back to only using DBCR0_IDM to determine if we are using
debug resources.
Signed-off-by: Kumar Gala <galak@kernel.crashing.org>
Signed-off-by: Benjamin Herrenschmidt <benh@kernel.crashing.org>
diff --git a/arch/powerpc/kernel/entry_32.S b/arch/powerpc/kernel/entry_32.S
index 81c8324..da52269 100644
--- a/arch/powerpc/kernel/entry_32.S
+++ b/arch/powerpc/kernel/entry_32.S
@@ -148,7 +148,7 @@
/* Check to see if the dbcr0 register is set up to debug. Use the
internal debug mode bit to do this. */
lwz r12,THREAD_DBCR0(r12)
- andis. r12,r12,(DBCR0_IDM | DBSR_DAC1R | DBSR_DAC1W)@h
+ andis. r12,r12,DBCR0_IDM@h
beq+ 3f
/* From user and task is ptraced - load up global dbcr0 */
li r12,-1 /* clear all pending debug events */
@@ -292,7 +292,7 @@
/* If the process has its own DBCR0 value, load it up. The internal
debug mode bit tells us that dbcr0 should be loaded. */
lwz r0,THREAD+THREAD_DBCR0(r2)
- andis. r10,r0,(DBCR0_IDM | DBSR_DAC1R | DBSR_DAC1W)@h
+ andis. r10,r0,DBCR0_IDM@h
bnel- load_dbcr0
#endif
#ifdef CONFIG_44x
@@ -720,7 +720,7 @@
/* Check whether this process has its own DBCR0 value. The internal
debug mode bit tells us that dbcr0 should be loaded. */
lwz r0,THREAD+THREAD_DBCR0(r2)
- andis. r10,r0,(DBCR0_IDM | DBSR_DAC1R | DBSR_DAC1W)@h
+ andis. r10,r0,DBCR0_IDM@h
bnel- load_dbcr0
#endif