regmap: irq: Allow to acknowledge masked interrupts during initialization
In case the hardware interrupt mask register does not prevent the chip level
irq from being asserted by the corresponding interrupt status bit, already
set interrupt bits should to be cleared once after masking them during
initialization. Add a flag to let drivers enable this behavior.
Signed-off-by: Philipp Zabel <p.zabel@pengutronix.de>
Signed-off-by: Mark Brown <broonie@linaro.org>
diff --git a/drivers/base/regmap/regmap-irq.c b/drivers/base/regmap/regmap-irq.c
index 1643e88..d10456f 100644
--- a/drivers/base/regmap/regmap-irq.c
+++ b/drivers/base/regmap/regmap-irq.c
@@ -418,6 +418,31 @@
reg, ret);
goto err_alloc;
}
+
+ if (!chip->init_ack_masked)
+ continue;
+
+ /* Ack masked but set interrupts */
+ reg = chip->status_base +
+ (i * map->reg_stride * d->irq_reg_stride);
+ ret = regmap_read(map, reg, &d->status_buf[i]);
+ if (ret != 0) {
+ dev_err(map->dev, "Failed to read IRQ status: %d\n",
+ ret);
+ goto err_alloc;
+ }
+
+ if (d->status_buf[i] && chip->ack_base) {
+ reg = chip->ack_base +
+ (i * map->reg_stride * d->irq_reg_stride);
+ ret = regmap_write(map, reg,
+ d->status_buf[i] & d->mask_buf[i]);
+ if (ret != 0) {
+ dev_err(map->dev, "Failed to ack 0x%x: %d\n",
+ reg, ret);
+ goto err_alloc;
+ }
+ }
}
/* Wake is disabled by default */