mtd: denali: split the generic driver and PCI layer
The Denali controller can also be found in SoC devices attached to a
simple bus. Move the PCI specific parts into denali_pci so that we can
add a denali_dt that uses the same driver but for a device tree driver
instead of a PCI based device.
Signed-off-by: Jamie Iles <jamie@jamieiles.com>
Signed-off-by: Artem Bityutskiy <artem.bityutskiy@linux.intel.com>
diff --git a/drivers/mtd/nand/denali.c b/drivers/mtd/nand/denali.c
index e706a23..0c8bb6b 100644
--- a/drivers/mtd/nand/denali.c
+++ b/drivers/mtd/nand/denali.c
@@ -16,14 +16,12 @@
* 51 Franklin St - Fifth Floor, Boston, MA 02110-1301 USA.
*
*/
-
#include <linux/interrupt.h>
#include <linux/delay.h>
#include <linux/dma-mapping.h>
#include <linux/wait.h>
#include <linux/mutex.h>
#include <linux/slab.h>
-#include <linux/pci.h>
#include <linux/mtd/mtd.h>
#include <linux/module.h>
@@ -89,13 +87,6 @@
* format the bank into the proper bits for the controller */
#define BANK(x) ((x) << 24)
-/* List of platforms this NAND controller has be integrated into */
-static const struct pci_device_id denali_pci_ids[] = {
- { PCI_VDEVICE(INTEL, 0x0701), INTEL_CE4100 },
- { PCI_VDEVICE(INTEL, 0x0809), INTEL_MRST },
- { /* end: all zeroes */ }
-};
-
/* forward declarations */
static void clear_interrupts(struct denali_nand_info *denali);
static uint32_t wait_for_irq(struct denali_nand_info *denali,
@@ -699,7 +690,7 @@
if (comp_res == 0) {
/* timeout */
- printk(KERN_ERR "timeout occurred, status = 0x%x, mask = 0x%x\n",
+ pr_err("timeout occurred, status = 0x%x, mask = 0x%x\n",
intr_status, irq_mask);
intr_status = 0;
@@ -1305,8 +1296,7 @@
/* TODO: Read OOB data */
break;
default:
- printk(KERN_ERR ": unsupported command"
- " received 0x%x\n", cmd);
+ pr_err(": unsupported command received 0x%x\n", cmd);
break;
}
}
@@ -1425,107 +1415,48 @@
denali->irq_status = 0;
}
-/* driver entry point */
-static int denali_pci_probe(struct pci_dev *dev, const struct pci_device_id *id)
+int denali_init(struct denali_nand_info *denali)
{
- int ret = -ENODEV;
- resource_size_t csr_base, mem_base;
- unsigned long csr_len, mem_len;
- struct denali_nand_info *denali;
+ int ret;
- denali = kzalloc(sizeof(*denali), GFP_KERNEL);
- if (!denali)
- return -ENOMEM;
-
- ret = pci_enable_device(dev);
- if (ret) {
- printk(KERN_ERR "Spectra: pci_enable_device failed.\n");
- goto failed_alloc_memery;
- }
-
- if (id->driver_data == INTEL_CE4100) {
+ if (denali->platform == INTEL_CE4100) {
/* Due to a silicon limitation, we can only support
* ONFI timing mode 1 and below.
*/
if (onfi_timing_mode < -1 || onfi_timing_mode > 1) {
- printk(KERN_ERR "Intel CE4100 only supports"
- " ONFI timing mode 1 or below\n");
- ret = -EINVAL;
- goto failed_enable_dev;
- }
- denali->platform = INTEL_CE4100;
- mem_base = pci_resource_start(dev, 0);
- mem_len = pci_resource_len(dev, 1);
- csr_base = pci_resource_start(dev, 1);
- csr_len = pci_resource_len(dev, 1);
- } else {
- denali->platform = INTEL_MRST;
- csr_base = pci_resource_start(dev, 0);
- csr_len = pci_resource_len(dev, 0);
- mem_base = pci_resource_start(dev, 1);
- mem_len = pci_resource_len(dev, 1);
- if (!mem_len) {
- mem_base = csr_base + csr_len;
- mem_len = csr_len;
+ pr_err("Intel CE4100 only supports ONFI timing mode 1 or below\n");
+ return -EINVAL;
}
}
/* Is 32-bit DMA supported? */
- ret = dma_set_mask(&dev->dev, DMA_BIT_MASK(32));
+ ret = dma_set_mask(denali->dev, DMA_BIT_MASK(32));
if (ret) {
- printk(KERN_ERR "Spectra: no usable DMA configuration\n");
- goto failed_enable_dev;
+ pr_err("Spectra: no usable DMA configuration\n");
+ return ret;
}
- denali->buf.dma_buf = dma_map_single(&dev->dev, denali->buf.buf,
+ denali->buf.dma_buf = dma_map_single(denali->dev, denali->buf.buf,
DENALI_BUF_SIZE,
DMA_BIDIRECTIONAL);
- if (dma_mapping_error(&dev->dev, denali->buf.dma_buf)) {
- dev_err(&dev->dev, "Spectra: failed to map DMA buffer\n");
- goto failed_enable_dev;
+ if (dma_mapping_error(denali->dev, denali->buf.dma_buf)) {
+ dev_err(denali->dev, "Spectra: failed to map DMA buffer\n");
+ return -EIO;
}
-
- pci_set_master(dev);
- denali->dev = &dev->dev;
- denali->mtd.dev.parent = &dev->dev;
-
- ret = pci_request_regions(dev, DENALI_NAND_NAME);
- if (ret) {
- printk(KERN_ERR "Spectra: Unable to request memory regions\n");
- goto failed_dma_map;
- }
-
- denali->flash_reg = ioremap_nocache(csr_base, csr_len);
- if (!denali->flash_reg) {
- printk(KERN_ERR "Spectra: Unable to remap memory region\n");
- ret = -ENOMEM;
- goto failed_req_regions;
- }
-
- denali->flash_mem = ioremap_nocache(mem_base, mem_len);
- if (!denali->flash_mem) {
- printk(KERN_ERR "Spectra: ioremap_nocache failed!");
- ret = -ENOMEM;
- goto failed_remap_reg;
- }
-
+ denali->mtd.dev.parent = denali->dev;
denali_hw_init(denali);
denali_drv_init(denali);
/* denali_isr register is done after all the hardware
* initilization is finished*/
- if (request_irq(dev->irq, denali_isr, IRQF_SHARED,
+ if (request_irq(denali->irq, denali_isr, IRQF_SHARED,
DENALI_NAND_NAME, denali)) {
- printk(KERN_ERR "Spectra: Unable to allocate IRQ\n");
- ret = -ENODEV;
- goto failed_remap_mem;
+ pr_err("Spectra: Unable to allocate IRQ\n");
+ return -ENODEV;
}
/* now that our ISR is registered, we can enable interrupts */
denali_set_intr_modes(denali, true);
-
- pci_set_drvdata(dev, denali);
-
denali->mtd.name = "denali-nand";
denali->mtd.owner = THIS_MODULE;
denali->mtd.priv = &denali->nand;
@@ -1549,8 +1480,7 @@
*/
if (denali->mtd.writesize > NAND_MAX_PAGESIZE + NAND_MAX_OOBSIZE) {
ret = -ENODEV;
- printk(KERN_ERR "Spectra: device size not supported by this "
- "version of MTD.");
+ pr_err("Spectra: device size not supported by this version of MTD.");
goto failed_req_irq;
}
@@ -1602,8 +1532,8 @@
} else if (denali->mtd.oobsize < (denali->bbtskipbytes +
ECC_8BITS * (denali->mtd.writesize /
ECC_SECTOR_SIZE))) {
- printk(KERN_ERR "Your NAND chip OOB is not large enough to"
- " contain 8bit ECC correction codes");
+ pr_err("Your NAND chip OOB is not large enough to \
+ contain 8bit ECC correction codes");
goto failed_req_irq;
} else {
denali->nand.ecc.strength = 8;
@@ -1655,56 +1585,24 @@
ret = mtd_device_register(&denali->mtd, NULL, 0);
if (ret) {
- dev_err(&dev->dev, "Spectra: Failed to register MTD: %d\n",
+ dev_err(denali->dev, "Spectra: Failed to register MTD: %d\n",
ret);
goto failed_req_irq;
}
return 0;
failed_req_irq:
- denali_irq_cleanup(dev->irq, denali);
-failed_remap_mem:
- iounmap(denali->flash_mem);
-failed_remap_reg:
- iounmap(denali->flash_reg);
-failed_req_regions:
- pci_release_regions(dev);
-failed_dma_map:
- dma_unmap_single(&dev->dev, denali->buf.dma_buf, DENALI_BUF_SIZE,
- DMA_BIDIRECTIONAL);
-failed_enable_dev:
- pci_disable_device(dev);
-failed_alloc_memery:
- kfree(denali);
+ denali_irq_cleanup(denali->irq, denali);
+
return ret;
}
+EXPORT_SYMBOL(denali_init);
/* driver exit point */
-static void denali_pci_remove(struct pci_dev *dev)
+void denali_remove(struct denali_nand_info *denali)
{
- struct denali_nand_info *denali = pci_get_drvdata(dev);
-
- nand_release(&denali->mtd);
-
- denali_irq_cleanup(dev->irq, denali);
-
- iounmap(denali->flash_reg);
- iounmap(denali->flash_mem);
- pci_release_regions(dev);
- pci_disable_device(dev);
- dma_unmap_single(&dev->dev, denali->buf.dma_buf, DENALI_BUF_SIZE,
- DMA_BIDIRECTIONAL);
- pci_set_drvdata(dev, NULL);
- kfree(denali);
+ denali_irq_cleanup(denali->irq, denali);
+ dma_unmap_single(denali->dev, denali->buf.dma_buf, DENALI_BUF_SIZE,
+ DMA_BIDIRECTIONAL);
}
-
-MODULE_DEVICE_TABLE(pci, denali_pci_ids);
-
-static struct pci_driver denali_pci_driver = {
- .name = DENALI_NAND_NAME,
- .id_table = denali_pci_ids,
- .probe = denali_pci_probe,
- .remove = denali_pci_remove,
-};
-
-module_pci_driver(denali_pci_driver);
+EXPORT_SYMBOL(denali_remove);