iwlwifi: create device configuration header file
The iwl-shared.h header file will be going away
soon. There isn't much left in it that we keep,
other than the device configuration declarations.
Move those out now to a new iwl-config.h header.
iwl-cfg.h seemed like a possible alternative but
those declarations will later live in the PCIe
transport code.
Signed-off-by: Johannes Berg <johannes.berg@intel.com>
Signed-off-by: Wey-Yi Guy <wey-yi.w.guy@intel.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/drivers/net/wireless/iwlwifi/iwl-shared.h b/drivers/net/wireless/iwlwifi/iwl-shared.h
index ee155e9..68f452d 100644
--- a/drivers/net/wireless/iwlwifi/iwl-shared.h
+++ b/drivers/net/wireless/iwlwifi/iwl-shared.h
@@ -70,6 +70,7 @@
#include "iwl-commands.h"
#include "iwl-fw.h"
+#include "iwl-config.h"
/**
* DOC: shared area - role and goal
@@ -95,7 +96,6 @@
struct iwl_priv;
struct iwl_trans;
-struct iwl_sensitivity_ranges;
struct iwl_trans_ops;
#define DRV_NAME "iwlwifi"
@@ -153,147 +153,6 @@
bool auto_agg;
};
-/*
- * LED mode
- * IWL_LED_DEFAULT: use device default
- * IWL_LED_RF_STATE: turn LED on/off based on RF state
- * LED ON = RF ON
- * LED OFF = RF OFF
- * IWL_LED_BLINK: adjust led blink rate based on blink table
- * IWL_LED_DISABLE: led disabled
- */
-enum iwl_led_mode {
- IWL_LED_DEFAULT,
- IWL_LED_RF_STATE,
- IWL_LED_BLINK,
- IWL_LED_DISABLE,
-};
-
-/*
- * @max_ll_items: max number of OTP blocks
- * @shadow_ram_support: shadow support for OTP memory
- * @led_compensation: compensate on the led on/off time per HW according
- * to the deviation to achieve the desired led frequency.
- * The detail algorithm is described in iwl-led.c
- * @chain_noise_num_beacons: number of beacons used to compute chain noise
- * @adv_thermal_throttle: support advance thermal throttle
- * @support_ct_kill_exit: support ct kill exit condition
- * @plcp_delta_threshold: plcp error rate threshold used to trigger
- * radio tuning when there is a high receiving plcp error rate
- * @chain_noise_scale: default chain noise scale used for gain computation
- * @wd_timeout: TX queues watchdog timeout
- * @max_event_log_size: size of event log buffer size for ucode event logging
- * @shadow_reg_enable: HW shadhow register bit
- * @hd_v2: v2 of enhanced sensitivity value, used for 2000 series and up
- * @no_idle_support: do not support idle mode
- */
-struct iwl_base_params {
- int eeprom_size;
- int num_of_queues; /* def: HW dependent */
- /* for iwl_apm_init() */
- u32 pll_cfg_val;
-
- const u16 max_ll_items;
- const bool shadow_ram_support;
- u16 led_compensation;
- bool adv_thermal_throttle;
- bool support_ct_kill_exit;
- u8 plcp_delta_threshold;
- s32 chain_noise_scale;
- unsigned int wd_timeout;
- u32 max_event_log_size;
- const bool shadow_reg_enable;
- const bool hd_v2;
- const bool no_idle_support;
-};
-
-/*
- * @advanced_bt_coexist: support advanced bt coexist
- * @bt_init_traffic_load: specify initial bt traffic load
- * @bt_prio_boost: default bt priority boost value
- * @agg_time_limit: maximum number of uSec in aggregation
- * @bt_sco_disable: uCode should not response to BT in SCO/ESCO mode
- */
-struct iwl_bt_params {
- bool advanced_bt_coexist;
- u8 bt_init_traffic_load;
- u8 bt_prio_boost;
- u16 agg_time_limit;
- bool bt_sco_disable;
- bool bt_session_2;
-};
-/*
- * @use_rts_for_aggregation: use rts/cts protection for HT traffic
- */
-struct iwl_ht_params {
- const bool ht_greenfield_support; /* if used set to true */
- bool use_rts_for_aggregation;
- enum ieee80211_smps_mode smps_mode;
-};
-
-/**
- * struct iwl_cfg
- * @name: Offical name of the device
- * @fw_name_pre: Firmware filename prefix. The api version and extension
- * (.ucode) will be added to filename before loading from disk. The
- * filename is constructed as fw_name_pre<api>.ucode.
- * @ucode_api_max: Highest version of uCode API supported by driver.
- * @ucode_api_ok: oldest version of the uCode API that is OK to load
- * without a warning, for use in transitions
- * @ucode_api_min: Lowest version of uCode API supported by driver.
- * @max_inst_size: The maximal length of the fw inst section
- * @max_data_size: The maximal length of the fw data section
- * @valid_tx_ant: valid transmit antenna
- * @valid_rx_ant: valid receive antenna
- * @eeprom_ver: EEPROM version
- * @eeprom_calib_ver: EEPROM calibration version
- * @lib: pointer to the lib ops
- * @additional_nic_config: additional nic configuration
- * @base_params: pointer to basic parameters
- * @ht_params: point to ht patameters
- * @bt_params: pointer to bt parameters
- * @need_temp_offset_calib: need to perform temperature offset calibration
- * @no_xtal_calib: some devices do not need crystal calibration data,
- * don't send it to those
- * @led_mode: 0=blinking, 1=On(RF On)/Off(RF Off)
- * @adv_pm: advance power management
- * @rx_with_siso_diversity: 1x1 device with rx antenna diversity
- * @internal_wimax_coex: internal wifi/wimax combo device
- * @temp_offset_v2: support v2 of temperature offset calibration
- *
- * We enable the driver to be backward compatible wrt. hardware features.
- * API differences in uCode shouldn't be handled here but through TLVs
- * and/or the uCode API version instead.
- */
-struct iwl_cfg {
- /* params specific to an individual device within a device family */
- const char *name;
- const char *fw_name_pre;
- const unsigned int ucode_api_max;
- const unsigned int ucode_api_ok;
- const unsigned int ucode_api_min;
- const u32 max_data_size;
- const u32 max_inst_size;
- u8 valid_tx_ant;
- u8 valid_rx_ant;
- u16 eeprom_ver;
- u16 eeprom_calib_ver;
- const struct iwl_lib_ops *lib;
- void (*additional_nic_config)(struct iwl_priv *priv);
- /* params not likely to change within a device family */
- const struct iwl_base_params *base_params;
- /* params likely to change within a device family */
- const struct iwl_ht_params *ht_params;
- const struct iwl_bt_params *bt_params;
- const bool need_temp_offset_calib; /* if used set to true */
- const bool no_xtal_calib;
- enum iwl_led_mode led_mode;
- const bool adv_pm;
- const bool rx_with_siso_diversity;
- const bool internal_wimax_coex;
- const bool temp_offset_v2;
-};
-
/**
* struct iwl_shared - shared fields for all the layers of the driver
*