[SCSI] Add a report opcode helper
The REPORT SUPPORTED OPERATION CODES command can be used to query
whether a given opcode is supported by a device. Add a helper function
that allows us to look up commands.
We only issue RSOC if the device reports compliance with SPC-3 or
later. But to err on the side of caution we disable the command for ATA,
FireWire and USB.
Signed-off-by: Martin K. Petersen <martin.petersen@oracle.com>
Acked-by: Mike Snitzer <snitzer@redhat.com>
Signed-off-by: James Bottomley <JBottomley@Parallels.com>
diff --git a/include/scsi/scsi_device.h b/include/scsi/scsi_device.h
index 88fae8d..379d465e 100644
--- a/include/scsi/scsi_device.h
+++ b/include/scsi/scsi_device.h
@@ -135,6 +135,7 @@
* because we did a bus reset. */
unsigned use_10_for_rw:1; /* first try 10-byte read / write */
unsigned use_10_for_ms:1; /* first try 10-byte mode sense/select */
+ unsigned no_report_opcodes:1; /* no REPORT SUPPORTED OPERATION CODES */
unsigned skip_ms_page_8:1; /* do not use MODE SENSE page 0x08 */
unsigned skip_ms_page_3f:1; /* do not use MODE SENSE page 0x3f */
unsigned skip_vpd_pages:1; /* do not read VPD pages */
@@ -362,6 +363,8 @@
int retries, struct scsi_sense_hdr *sshdr);
extern int scsi_get_vpd_page(struct scsi_device *, u8 page, unsigned char *buf,
int buf_len);
+extern int scsi_report_opcode(struct scsi_device *sdev, unsigned char *buffer,
+ unsigned int len, unsigned char opcode);
extern int scsi_device_set_state(struct scsi_device *sdev,
enum scsi_device_state state);
extern struct scsi_event *sdev_evt_alloc(enum scsi_device_event evt_type,