crypto: ux500/cryp - Set DMA configuration though dma_slave_config()
The DMA controller currently takes configuration information from
information passed though dma_channel_request(), but it shouldn't.
Using the API, the DMA channel should only be configured during
a dma_slave_config() call.
Cc: David S. Miller <davem@davemloft.net>
Cc: Andreas Westin <andreas.westin@stericsson.com>
Cc: linux-crypto@vger.kernel.org
Acked-by: Herbert Xu <herbert@gondor.apana.org.au>
Acked-by: Arnd Bergmann <arnd@arndb.de>
Acked-by: Linus Walleij <linus.walleij@linaro.org>
Signed-off-by: Lee Jones <lee.jones@linaro.org>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
diff --git a/drivers/crypto/ux500/cryp/cryp.h b/drivers/crypto/ux500/cryp/cryp.h
index 14cfd05..d1d6606 100644
--- a/drivers/crypto/ux500/cryp/cryp.h
+++ b/drivers/crypto/ux500/cryp/cryp.h
@@ -114,6 +114,9 @@
};
/* Cryp DMA interface */
+#define CRYP_DMA_TX_FIFO 0x08
+#define CRYP_DMA_RX_FIFO 0x10
+
enum cryp_dma_req_type {
CRYP_DMA_DISABLE_BOTH,
CRYP_DMA_ENABLE_IN_DATA,
@@ -217,7 +220,8 @@
/**
* struct cryp_device_data - structure for a cryp device.
- * @base: Pointer to the hardware base address.
+ * @base: Pointer to virtual base address of the cryp device.
+ * @phybase: Pointer to physical memory location of the cryp device.
* @dev: Pointer to the devices dev structure.
* @clk: Pointer to the device's clock control.
* @pwr_regulator: Pointer to the device's power control.
@@ -232,6 +236,7 @@
*/
struct cryp_device_data {
struct cryp_register __iomem *base;
+ phys_addr_t phybase;
struct device *dev;
struct clk *clk;
struct regulator *pwr_regulator;