ath5k: Cleanup after API changes
Cleanup after API changes patch (checkpatch.pl stuff) and on
ath5k_hw_channel() make use of the existing ath5k_channel_ok()
instead of re-implementing the checks again. This was necessary
to make the code cleaner and fit the 80-chars wide limit so
sending it within the same patch.
Finally make a note that we *may* eventually move cap_range stuff
to struct wiphy (band frequency range capabilities). This
information can later be exported to userspace, for example,
and giving it access to mac80211 and drivers in general can come
in handy.
Changes to initvals.c, phy.c
Changes-licensed-under: ISC
Changes to ath5k.h, base.c
Changes-licensed-under: 3-Clause-BSD
Signed-off-by: Luis R. Rodriguez <mcgrof@winlab.rutgers.edu>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/drivers/net/wireless/ath5k/ath5k.h b/drivers/net/wireless/ath5k/ath5k.h
index 9ea8c54..18223d9 100644
--- a/drivers/net/wireless/ath5k/ath5k.h
+++ b/drivers/net/wireless/ath5k/ath5k.h
@@ -263,8 +263,10 @@
/* adding this flag to rate_code enables short preamble, see ar5212_reg.h */
#define AR5K_SET_SHORT_PREAMBLE 0x04
-#define HAS_SHPREAMBLE(_ix) (rt->rates[_ix].modulation == IEEE80211_RATE_SHORT_PREAMBLE)
-#define SHPREAMBLE_FLAG(_ix) (HAS_SHPREAMBLE(_ix) ? AR5K_SET_SHORT_PREAMBLE : 0)
+#define HAS_SHPREAMBLE(_ix) \
+ (rt->rates[_ix].modulation == IEEE80211_RATE_SHORT_PREAMBLE)
+#define SHPREAMBLE_FLAG(_ix) \
+ (HAS_SHPREAMBLE(_ix) ? AR5K_SET_SHORT_PREAMBLE : 0)
/****************\
TX DEFINITIONS
@@ -892,6 +894,8 @@
AR5K_CAP_RFSILENT = 20, /* Supports RFsilent */
};
+
+/* XXX: we *may* move cap_range stuff to struct wiphy */
struct ath5k_capabilities {
/*
* Supported PHY modes