[WATCHDOG] mv64x60_wdt: set up platform_device in platform code
The driver previously registered its platform device data in its own
init function--that's bogus. Move that code to platform-specific
code in arch/ppc. This is being done so that the platform code can
decide at runtime whether to initialize this driver or not.
Signed-off-by: Dale Farnsworth <dale@farnsworth.org>
Signed-off-by: Wim Van Sebroeck <wim@iguana.be>
diff --git a/arch/ppc/syslib/mv64x60.c b/arch/ppc/syslib/mv64x60.c
index d212b1c..2744b8a 100644
--- a/arch/ppc/syslib/mv64x60.c
+++ b/arch/ppc/syslib/mv64x60.c
@@ -441,6 +441,32 @@
};
#endif
+#ifdef CONFIG_WATCHDOG
+static struct mv64x60_wdt_pdata mv64x60_wdt_pdata = {
+ .timeout = 10, /* default watchdog expiry in seconds */
+ .bus_clk = 133, /* default bus clock in MHz */
+};
+
+static struct resource mv64x60_wdt_resources[] = {
+ [0] = {
+ .name = "mv64x60 wdt base",
+ .start = MV64x60_WDT_WDC,
+ .end = MV64x60_WDT_WDC + 8 - 1, /* two 32-bit registers */
+ .flags = IORESOURCE_MEM,
+ },
+};
+
+static struct platform_device wdt_device = {
+ .name = MV64x60_WDT_NAME,
+ .id = 0,
+ .num_resources = ARRAY_SIZE(mv64x60_wdt_resources),
+ .resource = mv64x60_wdt_resources,
+ .dev = {
+ .platform_data = &mv64x60_wdt_pdata,
+ },
+};
+#endif
+
#if defined(CONFIG_SYSFS) && !defined(CONFIG_GT64260)
static struct mv64xxx_pdata mv64xxx_pdata = {
.hs_reg_valid = 0,
@@ -476,6 +502,9 @@
#ifdef CONFIG_I2C_MV64XXX
&i2c_device,
#endif
+#ifdef CONFIG_MV64X60_WDT
+ &wdt_device,
+#endif
#if defined(CONFIG_SYSFS) && !defined(CONFIG_GT64260)
&mv64xxx_device,
#endif