mac80211: move dynamic PS timeout to hardware config
This will be needed for drivers that set the
IEEE80211_HW_NO_STACK_DYNAMIC_PS flag and still
want to handle dynamic PS.
Signed-off-by: Johannes Berg <johannes@sipsolutions.net>
Reviewed-by: Kalle Valo <kalle.valo@nokia.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/include/net/mac80211.h b/include/net/mac80211.h
index 76537f1..83ee8a2 100644
--- a/include/net/mac80211.h
+++ b/include/net/mac80211.h
@@ -515,6 +515,7 @@
* @IEEE80211_CONF_CHANGE_LISTEN_INTERVAL: the listen interval changed
* @IEEE80211_CONF_CHANGE_RADIOTAP: the radiotap flag changed
* @IEEE80211_CONF_CHANGE_PS: the PS flag changed
+ * @IEEE80211_CONF_CHANGE_DYNPS_TIMEOUT: the dynamic PS timeout changed
* @IEEE80211_CONF_CHANGE_POWER: the TX power changed
* @IEEE80211_CONF_CHANGE_CHANNEL: the channel/channel_type changed
* @IEEE80211_CONF_CHANGE_RETRY_LIMITS: retry limits changed
@@ -525,9 +526,10 @@
IEEE80211_CONF_CHANGE_LISTEN_INTERVAL = BIT(2),
IEEE80211_CONF_CHANGE_RADIOTAP = BIT(3),
IEEE80211_CONF_CHANGE_PS = BIT(4),
- IEEE80211_CONF_CHANGE_POWER = BIT(5),
- IEEE80211_CONF_CHANGE_CHANNEL = BIT(6),
- IEEE80211_CONF_CHANGE_RETRY_LIMITS = BIT(7),
+ IEEE80211_CONF_CHANGE_DYNPS_TIMEOUT = BIT(5),
+ IEEE80211_CONF_CHANGE_POWER = BIT(6),
+ IEEE80211_CONF_CHANGE_CHANNEL = BIT(7),
+ IEEE80211_CONF_CHANGE_RETRY_LIMITS = BIT(8),
};
/**
@@ -540,6 +542,7 @@
* @listen_interval: listen interval in units of beacon interval
* @flags: configuration flags defined above
* @power_level: requested transmit power (in dBm)
+ * @dynamic_ps_timeout: dynamic powersave timeout (in ms)
* @channel: the channel to tune to
* @channel_type: the channel (HT) type
* @long_frame_max_tx_count: Maximum number of transmissions for a "long" frame
@@ -552,7 +555,7 @@
struct ieee80211_conf {
int beacon_int;
u32 flags;
- int power_level;
+ int power_level, dynamic_ps_timeout;
u16 listen_interval;
bool radio_enabled;