ARM: at91: add atmel-mci support for chips and boards which can use it
Since atmel-mci driver supports all atmel mci versions,
use it instead of the deprecated at91_mci driver.
Platform data and all related configuration are removed.
Signed-off-by: Ludovic Desroches <ludovic.desroches@atmel.com>
[nicolas.ferre@atmel.com: remove at91_mci platform data]
Signed-off-by: Nicolas Ferre <nicolas.ferre@atmel.com>
diff --git a/arch/arm/mach-at91/board-rm9200ek.c b/arch/arm/mach-at91/board-rm9200ek.c
index 2b15b8a..58144a0 100644
--- a/arch/arm/mach-at91/board-rm9200ek.c
+++ b/arch/arm/mach-at91/board-rm9200ek.c
@@ -69,12 +69,12 @@
};
#ifndef CONFIG_MTD_AT91_DATAFLASH_CARD
-static struct at91_mmc_data __initdata ek_mmc_data = {
- .det_pin = AT91_PIN_PB27,
- .slot_b = 0,
- .wire4 = 1,
- .wp_pin = AT91_PIN_PA17,
- .vcc_pin = -EINVAL,
+static struct mci_platform_data __initdata ek_mci0_data = {
+ .slot[0] = {
+ .bus_width = 4,
+ .detect_pin = AT91_PIN_PB27,
+ .wp_pin = AT91_PIN_PA17,
+ }
};
#endif
@@ -176,7 +176,7 @@
#else
/* MMC */
at91_set_gpio_output(AT91_PIN_PB22, 1); /* this MMC card slot can optionally use SPI signaling (CS3). */
- at91_add_device_mmc(0, &ek_mmc_data);
+ at91_add_device_mci(0, &ek_mci0_data);
#endif
/* NOR Flash */
platform_device_register(&ek_flash);