diff --git a/drivers/net/sky2.c b/drivers/net/sky2.c
index b1a675a..6d6a56b 100644
--- a/drivers/net/sky2.c
+++ b/drivers/net/sky2.c
@@ -365,6 +365,17 @@
 				gm_phy_write(hw, port, PHY_MARV_FE_SPEC_2, spec);
 			}
 		} else {
+			if (hw->chip_id >= CHIP_ID_YUKON_OPT) {
+				u16 ctrl2 = gm_phy_read(hw, port, PHY_MARV_EXT_CTRL_2);
+
+				/* enable PHY Reverse Auto-Negotiation */
+				ctrl2 |= 1u << 13;
+
+				/* Write PHY changes (SW-reset must follow) */
+				gm_phy_write(hw, port, PHY_MARV_EXT_CTRL_2, ctrl2);
+			}
+
+
 			/* disable energy detect */
 			ctrl &= ~PHY_M_PC_EN_DET_MSK;
 
@@ -626,6 +637,63 @@
 		if (ledover)
 			gm_phy_write(hw, port, PHY_MARV_LED_OVER, ledover);
 
+	} else if (hw->chip_id == CHIP_ID_YUKON_PRM &&
+		   (sky2_read8(hw, B2_MAC_CFG) & 0xf) == 0x7) {
+		int i;
+		/* This a phy register setup workaround copied from vendor driver. */
+		static const struct {
+			u16 reg, val;
+		} eee_afe[] = {
+			{ 0x156, 0x58ce },
+			{ 0x153, 0x99eb },
+			{ 0x141, 0x8064 },
+			/* { 0x155, 0x130b },*/
+			{ 0x000, 0x0000 },
+			{ 0x151, 0x8433 },
+			{ 0x14b, 0x8c44 },
+			{ 0x14c, 0x0f90 },
+			{ 0x14f, 0x39aa },
+			/* { 0x154, 0x2f39 },*/
+			{ 0x14d, 0xba33 },
+			{ 0x144, 0x0048 },
+			{ 0x152, 0x2010 },
+			/* { 0x158, 0x1223 },*/
+			{ 0x140, 0x4444 },
+			{ 0x154, 0x2f3b },
+			{ 0x158, 0xb203 },
+			{ 0x157, 0x2029 },
+		};
+
+		/* Start Workaround for OptimaEEE Rev.Z0 */
+		gm_phy_write(hw, port, PHY_MARV_EXT_ADR, 0x00fb);
+
+		gm_phy_write(hw, port,  1, 0x4099);
+		gm_phy_write(hw, port,  3, 0x1120);
+		gm_phy_write(hw, port, 11, 0x113c);
+		gm_phy_write(hw, port, 14, 0x8100);
+		gm_phy_write(hw, port, 15, 0x112a);
+		gm_phy_write(hw, port, 17, 0x1008);
+
+		gm_phy_write(hw, port, PHY_MARV_EXT_ADR, 0x00fc);
+		gm_phy_write(hw, port,  1, 0x20b0);
+
+		gm_phy_write(hw, port, PHY_MARV_EXT_ADR, 0x00ff);
+
+		for (i = 0; i < ARRAY_SIZE(eee_afe); i++) {
+			/* apply AFE settings */
+			gm_phy_write(hw, port, 17, eee_afe[i].val);
+			gm_phy_write(hw, port, 16, eee_afe[i].reg | 1u<<13);
+		}
+
+		/* End Workaround for OptimaEEE */
+		gm_phy_write(hw, port, PHY_MARV_EXT_ADR, 0);
+
+		/* Enable 10Base-Te (EEE) */
+		if (hw->chip_id >= CHIP_ID_YUKON_PRM) {
+			reg = gm_phy_read(hw, port, PHY_MARV_EXT_CTRL);
+			gm_phy_write(hw, port, PHY_MARV_EXT_CTRL,
+				     reg | PHY_M_10B_TE_ENABLE);
+		}
 	}
 
 	/* Enable phy interrupt on auto-negotiation complete (or link up) */
@@ -2959,6 +3027,8 @@
 	case CHIP_ID_YUKON_SUPR:
 	case CHIP_ID_YUKON_UL_2:
 	case CHIP_ID_YUKON_OPT:
+	case CHIP_ID_YUKON_PRM:
+	case CHIP_ID_YUKON_OP_2:
 		return 125;
 
 	case CHIP_ID_YUKON_FE:
@@ -3064,6 +3134,8 @@
 		break;
 
 	case CHIP_ID_YUKON_OPT:
+	case CHIP_ID_YUKON_PRM:
+	case CHIP_ID_YUKON_OP_2:
 		hw->flags = SKY2_HW_GIGABIT
 			| SKY2_HW_NEW_LE
 			| SKY2_HW_ADV_POWER_CTL;
@@ -3163,30 +3235,33 @@
 		sky2_pci_write32(hw, PCI_DEV_REG3, P_CLK_MACSEC_DIS);
 	}
 
-	if (hw->chip_id == CHIP_ID_YUKON_OPT) {
+	if (hw->chip_id == CHIP_ID_YUKON_OPT ||
+	    hw->chip_id == CHIP_ID_YUKON_PRM ||
+	    hw->chip_id == CHIP_ID_YUKON_OP_2) {
 		u16 reg;
 		u32 msk;
 
-		if (hw->chip_rev == 0) {
+		if (hw->chip_id == CHIP_ID_YUKON_OPT && hw->chip_rev == 0) {
 			/* disable PCI-E PHY power down (set PHY reg 0x80, bit 7 */
 			sky2_write32(hw, Y2_PEX_PHY_DATA, (0x80UL << 16) | (1 << 7));
 
 			/* set PHY Link Detect Timer to 1.1 second (11x 100ms) */
 			reg = 10;
+
+			/* re-enable PEX PM in PEX PHY debug reg. 8 (clear bit 12) */
+			sky2_write32(hw, Y2_PEX_PHY_DATA, PEX_DB_ACCESS | (0x08UL << 16));
 		} else {
 			/* set PHY Link Detect Timer to 0.4 second (4x 100ms) */
 			reg = 3;
 		}
 
 		reg <<= PSM_CONFIG_REG4_TIMER_PHY_LINK_DETECT_BASE;
+		reg |= PSM_CONFIG_REG4_RST_PHY_LINK_DETECT;
 
 		/* reset PHY Link Detect */
 		sky2_write8(hw, B2_TST_CTRL1, TST_CFG_WRITE_ON);
-		sky2_pci_write16(hw, PSM_CONFIG_REG4,
-				 reg | PSM_CONFIG_REG4_RST_PHY_LINK_DETECT);
 		sky2_pci_write16(hw, PSM_CONFIG_REG4, reg);
 
-
 		/* enable PHY Quick Link */
 		msk = sky2_read32(hw, B0_IMSK);
 		msk |= Y2_IS_PHY_QLNK;
@@ -4710,9 +4785,11 @@
 		"UL 2",		/* 0xba */
 		"Unknown",	/* 0xbb */
 		"Optima",	/* 0xbc */
+		"Optima Prime", /* 0xbd */
+		"Optima 2",	/* 0xbe */
 	};
 
-	if (chipid >= CHIP_ID_YUKON_XL && chipid <= CHIP_ID_YUKON_OPT)
+	if (chipid >= CHIP_ID_YUKON_XL && chipid <= CHIP_ID_YUKON_OP_2)
 		strncpy(buf, name[chipid - CHIP_ID_YUKON_XL], sz);
 	else
 		snprintf(buf, sz, "(chip %#x)", chipid);