ARM: at91/boards: use -EINVAL for invalid gpio
this will allow to use gpio_is_valid
Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
Cc: Nicolas Ferre <nicolas.ferre@atmel.com>
diff --git a/arch/arm/mach-at91/board-cpu9krea.c b/arch/arm/mach-at91/board-cpu9krea.c
index 5b55525..9ab3d1e 100644
--- a/arch/arm/mach-at91/board-cpu9krea.c
+++ b/arch/arm/mach-at91/board-cpu9krea.c
@@ -86,6 +86,8 @@
*/
static struct at91_usbh_data __initdata cpu9krea_usbh_data = {
.ports = 2,
+ .vbus_pin = {-EINVAL, -EINVAL},
+ .overcurrent_pin= {-EINVAL, -EINVAL},
};
/*
@@ -93,13 +95,14 @@
*/
static struct at91_udc_data __initdata cpu9krea_udc_data = {
.vbus_pin = AT91_PIN_PC8,
- .pullup_pin = 0, /* pull-up driven by UDC */
+ .pullup_pin = -EINVAL, /* pull-up driven by UDC */
};
/*
* MACB Ethernet device
*/
static struct macb_platform_data __initdata cpu9krea_macb_data = {
+ .phy_irq_pin = -EINVAL,
.is_rmii = 1,
};
@@ -112,6 +115,7 @@
.rdy_pin = AT91_PIN_PC13,
.enable_pin = AT91_PIN_PC14,
.bus_width_16 = 0,
+ .det_pin = -EINVAL,
};
#ifdef CONFIG_MACH_CPU9260
@@ -337,6 +341,8 @@
.slot_b = 0,
.wire4 = 1,
.det_pin = AT91_PIN_PA29,
+ .wp_pin = -EINVAL,
+ .vcc_pin = -EINVAL,
};
static void __init cpu9krea_board_init(void)