ARM: OMAP: Add flag to indicate if a timer needs a manual reset
For OMAP1 devices, it is necessary to perform a manual reset of the timer.
Currently, this is indicating by setting the "needs_manual_reset" variable in
the platform data. Instead of using an extra variable to indicate this add a new
timer capabilities flag to indicate this and remove the "needs_manual_reset"
member from the platform data.
Signed-off-by: Jon Hunter <jon-hunter@ti.com>
Signed-off-by: Tony Lindgren <tony@atomide.com>
diff --git a/arch/arm/plat-omap/dmtimer.c b/arch/arm/plat-omap/dmtimer.c
index 7875eef..e3e22b3 100644
--- a/arch/arm/plat-omap/dmtimer.c
+++ b/arch/arm/plat-omap/dmtimer.c
@@ -135,7 +135,6 @@
int omap_dm_timer_prepare(struct omap_dm_timer *timer)
{
- struct dmtimer_platform_data *pdata = timer->pdev->dev.platform_data;
int ret;
timer->fclk = clk_get(&timer->pdev->dev, "fck");
@@ -145,7 +144,7 @@
return -EINVAL;
}
- if (pdata->needs_manual_reset)
+ if (timer->capability & OMAP_TIMER_NEEDS_RESET)
omap_dm_timer_reset(timer);
ret = omap_dm_timer_set_source(timer, OMAP_TIMER_SRC_32_KHZ);
@@ -363,13 +362,11 @@
int omap_dm_timer_stop(struct omap_dm_timer *timer)
{
unsigned long rate = 0;
- struct dmtimer_platform_data *pdata;
if (unlikely(!timer))
return -EINVAL;
- pdata = timer->pdev->dev.platform_data;
- if (!pdata->needs_manual_reset)
+ if (!(timer->capability & OMAP_TIMER_NEEDS_RESET))
rate = clk_get_rate(timer->fclk);
__omap_dm_timer_stop(timer, timer->posted, rate);
@@ -694,7 +691,7 @@
timer->capability = pdata->timer_capability;
/* Skip pm_runtime_enable for OMAP1 */
- if (!pdata->needs_manual_reset) {
+ if (!(timer->capability & OMAP_TIMER_NEEDS_RESET)) {
pm_runtime_enable(&pdev->dev);
pm_runtime_irq_safe(&pdev->dev);
}