mtd: flash drivers set ecc strength
Flash device drivers initialize 'ecc_strength' in struct mtd_info, which is the
maximum number of bit errors that can be corrected in one writesize region.
Drivers using the nand interface intitialize 'strength' in struct nand_ecc_ctrl,
which is the maximum number of bit errors that can be corrected in one ecc step.
Nand infrastructure code translates this to 'ecc_strength'.
Also for nand drivers, the nand infrastructure code sets ecc.strength for ecc
modes NAND_ECC_SOFT, NAND_ECC_SOFT_BCH, and NAND_ECC_NONE. It is set in the
driver for all other modes.
Signed-off-by: Mike Dunn <mikedunn@newsguy.com>
Signed-off-by: Artem Bityutskiy <artem.bityutskiy@linux.intel.com>
Signed-off-by: David Woodhouse <David.Woodhouse@intel.com>
diff --git a/drivers/mtd/nand/r852.c b/drivers/mtd/nand/r852.c
index 769a4e0..c204018 100644
--- a/drivers/mtd/nand/r852.c
+++ b/drivers/mtd/nand/r852.c
@@ -891,6 +891,7 @@
chip->ecc.mode = NAND_ECC_HW_SYNDROME;
chip->ecc.size = R852_DMA_LEN;
chip->ecc.bytes = SM_OOB_SIZE;
+ chip->ecc.strength = 2;
chip->ecc.hwctl = r852_ecc_hwctl;
chip->ecc.calculate = r852_ecc_calculate;
chip->ecc.correct = r852_ecc_correct;