mtd: flash drivers set ecc strength
Flash device drivers initialize 'ecc_strength' in struct mtd_info, which is the
maximum number of bit errors that can be corrected in one writesize region.
Drivers using the nand interface intitialize 'strength' in struct nand_ecc_ctrl,
which is the maximum number of bit errors that can be corrected in one ecc step.
Nand infrastructure code translates this to 'ecc_strength'.
Also for nand drivers, the nand infrastructure code sets ecc.strength for ecc
modes NAND_ECC_SOFT, NAND_ECC_SOFT_BCH, and NAND_ECC_NONE. It is set in the
driver for all other modes.
Signed-off-by: Mike Dunn <mikedunn@newsguy.com>
Signed-off-by: Artem Bityutskiy <artem.bityutskiy@linux.intel.com>
Signed-off-by: David Woodhouse <David.Woodhouse@intel.com>
diff --git a/drivers/mtd/nand/tmio_nand.c b/drivers/mtd/nand/tmio_nand.c
index 060848a..5aa5180 100644
--- a/drivers/mtd/nand/tmio_nand.c
+++ b/drivers/mtd/nand/tmio_nand.c
@@ -430,6 +430,7 @@
nand_chip->ecc.mode = NAND_ECC_HW;
nand_chip->ecc.size = 512;
nand_chip->ecc.bytes = 6;
+ nand_chip->ecc.strength = 2;
nand_chip->ecc.hwctl = tmio_nand_enable_hwecc;
nand_chip->ecc.calculate = tmio_nand_calculate_ecc;
nand_chip->ecc.correct = tmio_nand_correct_data;