wlcore: move wl12xx_platform_data up and make it truly optional
The platform data is used not only by wlcore-based drivers, but also
by wl1251. Move it up in the directory hierarchy to reflect this.
Additionally, make it truly optional. At the moment, disabling
platform data while wl1251_sdio or wlcore_sdio are enabled doesn't
work, but it will be necessary when device tree support is
implemented.
Signed-off-by: Luciano Coelho <coelho@ti.com>
Reviewed-by: Felipe Balbi <balbi@ti.com>
diff --git a/arch/arm/mach-omap2/board-omap3evm.c b/arch/arm/mach-omap2/board-omap3evm.c
index 3985f35..a4ca63b 100644
--- a/arch/arm/mach-omap2/board-omap3evm.c
+++ b/arch/arm/mach-omap2/board-omap3evm.c
@@ -309,7 +309,7 @@
.gpio_wp = 63,
.deferred = true,
},
-#ifdef CONFIG_WL12XX_PLATFORM_DATA
+#ifdef CONFIG_WILINK_PLATFORM_DATA
{
.name = "wl1271",
.mmc = 2,
@@ -450,7 +450,7 @@
.consumer_supplies = omap3evm_vio_supply,
};
-#ifdef CONFIG_WL12XX_PLATFORM_DATA
+#ifdef CONFIG_WILINK_PLATFORM_DATA
#define OMAP3EVM_WLAN_PMENA_GPIO (150)
#define OMAP3EVM_WLAN_IRQ_GPIO (149)
@@ -563,7 +563,7 @@
OMAP_PIN_OFF_NONE),
OMAP3_MUX(GPMC_WAIT2, OMAP_MUX_MODE4 | OMAP_PIN_INPUT_PULLUP |
OMAP_PIN_OFF_NONE),
-#ifdef CONFIG_WL12XX_PLATFORM_DATA
+#ifdef CONFIG_WILINK_PLATFORM_DATA
/* WLAN IRQ - GPIO 149 */
OMAP3_MUX(UART1_RTS, OMAP_MUX_MODE4 | OMAP_PIN_INPUT),
@@ -601,7 +601,7 @@
OMAP3_MUX(SYS_BOOT4, OMAP_MUX_MODE3 | OMAP_PIN_OFF_NONE),
OMAP3_MUX(SYS_BOOT5, OMAP_MUX_MODE3 | OMAP_PIN_OFF_NONE),
OMAP3_MUX(SYS_BOOT6, OMAP_MUX_MODE3 | OMAP_PIN_OFF_NONE),
-#ifdef CONFIG_WL12XX_PLATFORM_DATA
+#ifdef CONFIG_WILINK_PLATFORM_DATA
/* WLAN IRQ - GPIO 149 */
OMAP3_MUX(UART1_RTS, OMAP_MUX_MODE4 | OMAP_PIN_INPUT),
@@ -637,7 +637,7 @@
static void __init omap3_evm_wl12xx_init(void)
{
-#ifdef CONFIG_WL12XX_PLATFORM_DATA
+#ifdef CONFIG_WILINK_PLATFORM_DATA
int ret;
/* WL12xx WLAN Init */