USB: EHCI: make ehci-orion a separate driver
With the multiplatform changes in arm-soc tree, it becomes
possible to enable the mvebu platform (which uses
ehci-orion) at the same time as other platforms that require
a conflicting EHCI bus glue. At the moment, this results
in a warning like
drivers/usb/host/ehci-hcd.c:1297:0: warning: "PLATFORM_DRIVER" redefined [enabled by default]
drivers/usb/host/ehci-hcd.c:1277:0: note: this is the location of the previous definition
drivers/usb/host/ehci-orion.c:334:31: warning: 'ehci_orion_driver' defined but not used [-Wunused-variable]
and an ehci driver that only works on one of them.
With the infrastructure added by Alan Stern in patch 3e0232039
"USB: EHCI: prepare to make ehci-hcd a library module", we can
avoid this problem by turning a bus glue into a separate
module, as we do here for the orion bus glue.
Signed-off-by: Manjunath Goudar <manjunath.goudar@linaro.org>
Signed-off-by: Arnd Bergmann <arnd@arndb.de>
Cc: Jason Cooper <jason@lakedaemon.net>
Cc: Andrew Lunn <andrew@lunn.ch>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
diff --git a/drivers/usb/host/Kconfig b/drivers/usb/host/Kconfig
index d77e028..7ac6f48 100644
--- a/drivers/usb/host/Kconfig
+++ b/drivers/usb/host/Kconfig
@@ -162,6 +162,14 @@
Enables support for the on-chip EHCI controller on
OMAP3 and later chips.
+config USB_EHCI_HCD_ORION
+ tristate "Support for Marvell Orion on-chip EHCI USB controller"
+ depends on USB_EHCI_HCD && PLAT_ORION
+ default y
+ ---help---
+ Enables support for the on-chip EHCI controller on
+ Morvell Orion chips.
+
config USB_EHCI_HCD_VT8500
tristate "Support for VT8500 on-chip EHCI USB controller"
depends on USB_EHCI_HCD && ARCH_VT8500