USB: pl2303: fix abuse of interface data
Fix abuse of interface data which was used to signal device disconnect.
Use the usb_serial disconnect flag and mutex where appropriate.
Note that tiocmget does not need to check for disconnect as it does not
access the device.
Signed-off-by: Johan Hovold <jhovold@gmail.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
diff --git a/drivers/usb/serial/pl2303.c b/drivers/usb/serial/pl2303.c
index a1a9062..4917b4e 100644
--- a/drivers/usb/serial/pl2303.c
+++ b/drivers/usb/serial/pl2303.c
@@ -523,12 +523,11 @@
unsigned int set, unsigned int clear)
{
struct usb_serial_port *port = tty->driver_data;
+ struct usb_serial *serial = port->serial;
struct pl2303_private *priv = usb_get_serial_port_data(port);
unsigned long flags;
u8 control;
-
- if (!usb_get_intfdata(port->serial->interface))
- return -ENODEV;
+ int ret;
spin_lock_irqsave(&priv->lock, flags);
if (set & TIOCM_RTS)
@@ -542,7 +541,14 @@
control = priv->line_control;
spin_unlock_irqrestore(&priv->lock, flags);
- return set_control_lines(port->serial->dev, control);
+ mutex_lock(&serial->disc_mutex);
+ if (!serial->disconnected)
+ ret = set_control_lines(serial->dev, control);
+ else
+ ret = -ENODEV;
+ mutex_unlock(&serial->disc_mutex);
+
+ return ret;
}
static int pl2303_tiocmget(struct tty_struct *tty)
@@ -556,9 +562,6 @@
dbg("%s (%d)", __func__, port->number);
- if (!usb_get_intfdata(port->serial->interface))
- return -ENODEV;
-
spin_lock_irqsave(&priv->lock, flags);
mcr = priv->line_control;
status = priv->line_status;