ethtool: cosmetic: Use ethtool ethtool_cmd_speed API
This updates the network drivers so that they don't access the
ethtool_cmd::speed field directly, but use ethtool_cmd_speed()
instead.
For most of the drivers, these changes are purely cosmetic and don't
fix any problem, such as for those 1GbE/10GbE drivers that indirectly
call their own ethtool get_settings()/mii_ethtool_gset(). The changes
are meant to enforce code consistency and provide robustness with
future larger throughputs, at the expense of a few CPU cycles for each
ethtool operation.
All drivers compiled with make allyesconfig ion x86_64 have been
updated.
Tested: make allyesconfig on x86_64 + e1000e/bnx2x work
Signed-off-by: David Decotigny <decot@google.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/sfc/ethtool.c b/drivers/net/sfc/ethtool.c
index 10b160a..8c5e005 100644
--- a/drivers/net/sfc/ethtool.c
+++ b/drivers/net/sfc/ethtool.c
@@ -219,7 +219,7 @@
ecmd->supported |= SUPPORTED_Pause | SUPPORTED_Asym_Pause;
if (LOOPBACK_INTERNAL(efx)) {
- ecmd->speed = link_state->speed;
+ ethtool_cmd_speed_set(ecmd, link_state->speed);
ecmd->duplex = link_state->fd ? DUPLEX_FULL : DUPLEX_HALF;
}
diff --git a/drivers/net/sfc/mcdi_phy.c b/drivers/net/sfc/mcdi_phy.c
index 6c5fccb..6c63ab0 100644
--- a/drivers/net/sfc/mcdi_phy.c
+++ b/drivers/net/sfc/mcdi_phy.c
@@ -513,7 +513,7 @@
ecmd->supported =
mcdi_to_ethtool_cap(phy_cfg->media, phy_cfg->supported_cap);
ecmd->advertising = efx->link_advertising;
- ecmd->speed = efx->link_state.speed;
+ ethtool_cmd_speed_set(ecmd, efx->link_state.speed);
ecmd->duplex = efx->link_state.fd;
ecmd->port = mcdi_to_ethtool_media(phy_cfg->media);
ecmd->phy_address = phy_cfg->port;
diff --git a/drivers/net/sfc/tenxpress.c b/drivers/net/sfc/tenxpress.c
index 204ecda..7b0fd89 100644
--- a/drivers/net/sfc/tenxpress.c
+++ b/drivers/net/sfc/tenxpress.c
@@ -460,7 +460,7 @@
/* In loopback, the PHY automatically brings up the correct interface,
* but doesn't advertise the correct speed. So override it */
if (LOOPBACK_EXTERNAL(efx))
- ecmd->speed = SPEED_10000;
+ ethtool_cmd_speed_set(ecmd, SPEED_10000);
}
static int tenxpress_set_settings(struct efx_nic *efx, struct ethtool_cmd *ecmd)