ARM: at91: do not pin mux the UARTs in init_early
There is no need to pinmux the UART so early in the kernel.
Move it to the board init.
This will also allow to finally move the gpio driver to platform device/driver.
Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
Acked-by: Nicolas Ferre <nicolas.ferre@atmel.com>
diff --git a/arch/arm/mach-at91/board-kb9202.c b/arch/arm/mach-at91/board-kb9202.c
index ccbc8be..e71b9e1 100644
--- a/arch/arm/mach-at91/board-kb9202.c
+++ b/arch/arm/mach-at91/board-kb9202.c
@@ -53,18 +53,6 @@
/* Set up the LEDs */
at91_init_leds(AT91_PIN_PC19, AT91_PIN_PC18);
-
- /* DBGU on ttyS0. (Rx & Tx only) */
- at91_register_uart(0, 0, 0);
-
- /* USART0 on ttyS1 (Rx & Tx only) */
- at91_register_uart(AT91RM9200_ID_US0, 1, 0);
-
- /* USART1 on ttyS2 (Rx & Tx only) - IRDA (optional) */
- at91_register_uart(AT91RM9200_ID_US1, 2, 0);
-
- /* USART3 on ttyS3 (Rx, Tx, CTS, RTS) - RS485 (optional) */
- at91_register_uart(AT91RM9200_ID_US3, 3, ATMEL_UART_CTS | ATMEL_UART_RTS);
}
static struct macb_platform_data __initdata kb9202_eth_data = {
@@ -113,6 +101,17 @@
static void __init kb9202_board_init(void)
{
/* Serial */
+ /* DBGU on ttyS0. (Rx & Tx only) */
+ at91_register_uart(0, 0, 0);
+
+ /* USART0 on ttyS1 (Rx & Tx only) */
+ at91_register_uart(AT91RM9200_ID_US0, 1, 0);
+
+ /* USART1 on ttyS2 (Rx & Tx only) - IRDA (optional) */
+ at91_register_uart(AT91RM9200_ID_US1, 2, 0);
+
+ /* USART3 on ttyS3 (Rx, Tx, CTS, RTS) - RS485 (optional) */
+ at91_register_uart(AT91RM9200_ID_US3, 3, ATMEL_UART_CTS | ATMEL_UART_RTS);
at91_add_device_serial();
/* Ethernet */
at91_add_device_eth(&kb9202_eth_data);