cnic, bnx2: Check iSCSI support early in bnx2_init_one()
Based on earlier patch from Neil Horman <nhorman@tuxdriver.com>
If iSCSI is not supported on a bnx2 device, bnx2_cnic_probe() will
return NULL and the cnic device will not be visible to bnx2i. This
will prevent bnx2i from registering and then unregistering during
cnic_start() and cause the warning message:
bnx2 0003:01:00.1: eth1: Failed waiting for ULP up call to complete
Signed-off-by: Michael Chan <mchan@broadcom.com>
Cc: Neil Horman <nhorman@tuxdriver.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/bnx2.c b/drivers/net/bnx2.c
index 57d3293..74580bb 100644
--- a/drivers/net/bnx2.c
+++ b/drivers/net/bnx2.c
@@ -416,6 +416,9 @@
struct bnx2 *bp = netdev_priv(dev);
struct cnic_eth_dev *cp = &bp->cnic_eth_dev;
+ if (!cp->max_iscsi_conn)
+ return NULL;
+
cp->drv_owner = THIS_MODULE;
cp->chip_id = bp->chip_id;
cp->pdev = bp->pdev;
@@ -8177,6 +8180,10 @@
bp->timer.data = (unsigned long) bp;
bp->timer.function = bnx2_timer;
+#ifdef BCM_CNIC
+ bp->cnic_eth_dev.max_iscsi_conn =
+ bnx2_reg_rd_ind(bp, BNX2_FW_MAX_ISCSI_CONN);
+#endif
pci_save_state(pdev);
return 0;