ARM: at91: move at91_init_leds to board init
This will also allow to finally move the gpio driver to platform device/driver.
Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
Acked-by: Nicolas Ferre <nicolas.ferre@atmel.com>
diff --git a/arch/arm/mach-at91/board-kb9202.c b/arch/arm/mach-at91/board-kb9202.c
index e71b9e1..ba39db5 100644
--- a/arch/arm/mach-at91/board-kb9202.c
+++ b/arch/arm/mach-at91/board-kb9202.c
@@ -50,9 +50,6 @@
/* Initialize processor: 10 MHz crystal */
at91_initialize(10000000);
-
- /* Set up the LEDs */
- at91_init_leds(AT91_PIN_PC19, AT91_PIN_PC18);
}
static struct macb_platform_data __initdata kb9202_eth_data = {
@@ -100,6 +97,9 @@
static void __init kb9202_board_init(void)
{
+ /* Set up the LEDs */
+ at91_init_leds(AT91_PIN_PC19, AT91_PIN_PC18);
+
/* Serial */
/* DBGU on ttyS0. (Rx & Tx only) */
at91_register_uart(0, 0, 0);