ARM: at91: move at91_init_leds to board init
This will also allow to finally move the gpio driver to platform device/driver.
Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
Acked-by: Nicolas Ferre <nicolas.ferre@atmel.com>
diff --git a/arch/arm/mach-at91/board-sam9-l9260.c b/arch/arm/mach-at91/board-sam9-l9260.c
index 5343dab..cdd21f2 100644
--- a/arch/arm/mach-at91/board-sam9-l9260.c
+++ b/arch/arm/mach-at91/board-sam9-l9260.c
@@ -48,9 +48,6 @@
{
/* Initialize processor: 18.432 MHz crystal */
at91_initialize(18432000);
-
- /* Setup the LEDs */
- at91_init_leds(AT91_PIN_PA9, AT91_PIN_PA6);
}
/*
@@ -170,6 +167,9 @@
static void __init ek_board_init(void)
{
+ /* Setup the LEDs */
+ at91_init_leds(AT91_PIN_PA9, AT91_PIN_PA6);
+
/* Serial */
/* DBGU on ttyS0. (Rx & Tx only) */
at91_register_uart(0, 0, 0);