ARC: [plat-arfpga] BVCI Latency Unit setup
Signed-off-by: Vineet Gupta <vgupta@synopsys.com>
diff --git a/arch/arc/plat-arcfpga/Kconfig b/arch/arc/plat-arcfpga/Kconfig
index 38752bf..9912d9c 100644
--- a/arch/arc/plat-arcfpga/Kconfig
+++ b/arch/arc/plat-arcfpga/Kconfig
@@ -44,4 +44,36 @@
help
Baud rate for the ARC UART
+menuconfig ARC_HAS_BVCI_LAT_UNIT
+ bool "BVCI Bus Latency Unit"
+ depends on ARC_BOARD_ML509 || ARC_BOARD_ANGEL4
+ help
+ IP to add artifical latency to BVCI Bus Based FPGA builds.
+ The default latency (even worst case) for FPGA is non-realistic
+ (~10 SDRAM, ~5 SSRAM).
+
+config BVCI_LAT_UNITS
+ hex "Latency Unit(s) Bitmap"
+ default "0x0"
+ depends on ARC_HAS_BVCI_LAT_UNIT
+ help
+ There are multiple Latency Units corresponding to the many
+ interfaces of the system bus arbiter (both CPU side as well as
+ the peripheral side).
+ To add latency to ALL memory transaction, choose Unit 0, otherwise
+ for finer grainer - interface wise latency, specify a bitmap (1 bit
+ per unit) of all units. e.g. 1,2,12 will be 0x1003
+
+ Unit 0 - System Arb and Mem Controller
+ Unit 1 - I$ and System Bus
+ Unit 2 - D$ and System Bus
+ ..
+ Unit 12 - IDE Disk controller and System Bus
+
+config BVCI_LAT_CYCLES
+ int "Latency Value in cycles"
+ range 0 63
+ default "30"
+ depends on ARC_HAS_BVCI_LAT_UNIT
+
endif