mac80211: Re-enable aggregation
Wireless HW without any dedicated queues for aggregation
do not need the ampdu_queues mechanism present right now
in mac80211. Since mac80211 is still incomplete wrt TX MQ
changes, do not allow aggregation sessions for drivers that
set ampdu_queues.
This is only an interim hack until Intel fixes the requeue issue.
Signed-off-by: Sujith <Sujith.Manoharan@atheros.com>
Signed-off-by: Luis Rodriguez <Luis.Rodriguez@Atheros.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/drivers/net/wireless/ath9k/main.c b/drivers/net/wireless/ath9k/main.c
index 795fed5..f6dc4c8 100644
--- a/drivers/net/wireless/ath9k/main.c
+++ b/drivers/net/wireless/ath9k/main.c
@@ -953,10 +953,7 @@
&sc->sbands[IEEE80211_BAND_5GHZ];
}
- /* FIXME: Have to figure out proper hw init values later */
-
hw->queues = 4;
- hw->ampdu_queues = 1;
/* Register rate control */
hw->rate_control_algorithm = "ath9k_rate_control";
@@ -1745,7 +1742,8 @@
hw->flags = IEEE80211_HW_RX_INCLUDES_FCS |
IEEE80211_HW_HOST_BROADCAST_PS_BUFFERING |
IEEE80211_HW_SIGNAL_DBM |
- IEEE80211_HW_NOISE_DBM;
+ IEEE80211_HW_NOISE_DBM |
+ IEEE80211_HW_AMPDU_AGGREGATION;
hw->wiphy->interface_modes =
BIT(NL80211_IFTYPE_AP) |