[ALSA] _snd_cmipci_uswitch_put doesn't set zero flags
Playing with spdif output on cmipci i've noticed the SPDO5V option does
not change appropriate bits the register.
The _snd_cmipci_uswitch_put checks the change in flags in wrong way.
If 'active' state of an option corresponds to a _zero_ bits in a hw
register then function fails. The SPDO5V is the sample.
In the most cases 'active' state of option is set through an non-zerio
bits in a register. This case works fine.
The fix attached.
Unfortunately i was unable to change spdif output voltage anyway.
Although the register changes right at least.
From: Timofei V. Bondarenko <tim@ipi.ac.ru>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Signed-off-by: Jaroslav Kysela <perex@suse.cz>
diff --git a/sound/pci/cmipci.c b/sound/pci/cmipci.c
index 71c58df..70face7 100644
--- a/sound/pci/cmipci.c
+++ b/sound/pci/cmipci.c
@@ -2198,7 +2198,8 @@
val = inb(cm->iobase + args->reg);
else
val = snd_cmipci_read(cm, args->reg);
- change = (val & args->mask) != (ucontrol->value.integer.value[0] ? args->mask : 0);
+ change = (val & args->mask) != (ucontrol->value.integer.value[0] ?
+ args->mask_on : (args->mask & ~args->mask_on));
if (change) {
val &= ~args->mask;
if (ucontrol->value.integer.value[0])