atl1c: Add AR8151 v2 support and change L0s/L1 routine
Add AR8151 v2.0 Gigabit 1000 support
Change jumbo frame size to 6K
Update L0s/L1 rountine
when link speed is 100M or 1G, set L1 link timer to 4 for l1d_2 and l2c_b2
set L1 link timer to 7 for l2c_b, set L1 link timer to 0xF for others.
Update atl1c_suspend routine
just refactory the function, add atl1c_phy_power_saving routine,
when Wake On Lan enable, this func will be called to save power,
it will reautoneg PHY to 10/100M speed depend on the link
partners link capability.
Update atl1c_configure_des_ring
do not use l2c_b default SRAM configuration.
Signed-off-by: Jie Yang <Jie.Yang@atheros.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/atl1c/atl1c.h b/drivers/net/atl1c/atl1c.h
index 84ae905..52abbbd 100644
--- a/drivers/net/atl1c/atl1c.h
+++ b/drivers/net/atl1c/atl1c.h
@@ -73,7 +73,8 @@
#define FULL_DUPLEX 2
#define AT_RX_BUF_SIZE (ETH_FRAME_LEN + VLAN_HLEN + ETH_FCS_LEN)
-#define MAX_JUMBO_FRAME_SIZE (9*1024)
+#define MAX_JUMBO_FRAME_SIZE (6*1024)
+#define MAX_TSO_FRAME_SIZE (7*1024)
#define MAX_TX_OFFLOAD_THRESH (9*1024)
#define AT_MAX_RECEIVE_QUEUE 4
@@ -87,10 +88,11 @@
#define AT_MAX_INT_WORK 5
#define AT_TWSI_EEPROM_TIMEOUT 100
#define AT_HW_MAX_IDLE_DELAY 10
-#define AT_SUSPEND_LINK_TIMEOUT 28
+#define AT_SUSPEND_LINK_TIMEOUT 100
#define AT_ASPM_L0S_TIMER 6
#define AT_ASPM_L1_TIMER 12
+#define AT_LCKDET_TIMER 12
#define ATL1C_PCIE_L0S_L1_DISABLE 0x01
#define ATL1C_PCIE_PHY_RESET 0x02
@@ -316,6 +318,7 @@
athr_l2c_b,
athr_l2c_b2,
athr_l1d,
+ athr_l1d_2,
};
enum atl1c_trans_queue {
@@ -392,6 +395,8 @@
u16 subsystem_id;
u16 subsystem_vendor_id;
u8 revision_id;
+ u16 phy_id1;
+ u16 phy_id2;
u32 intr_mask;
u8 dmaw_dly_cnt;