pcmcia: do not use io_req_t when calling pcmcia_request_io()
Instead of io_req_t, drivers are now requested to fill out
struct pcmcia_device *p_dev->resource[0,1] for up to two ioport
ranges. After a call to pcmcia_request_io(), the ports found there
are reserved, after calling pcmcia_request_configuration(), they may
be used.
CC: netdev@vger.kernel.org
CC: linux-wireless@vger.kernel.org
CC: linux-ide@vger.kernel.org
CC: linux-usb@vger.kernel.org
CC: laforge@gnumonks.org
CC: linux-mtd@lists.infradead.org
CC: alsa-devel@alsa-project.org
CC: linux-serial@vger.kernel.org
CC: Michael Buesch <mb@bu3sch.de>
Acked-by: Marcel Holtmann <marcel@holtmann.org> (for drivers/bluetooth/)
Signed-off-by: Dominik Brodowski <linux@dominikbrodowski.net>
diff --git a/drivers/net/pcmcia/ibmtr_cs.c b/drivers/net/pcmcia/ibmtr_cs.c
index e99abaa..3fd8595 100644
--- a/drivers/net/pcmcia/ibmtr_cs.c
+++ b/drivers/net/pcmcia/ibmtr_cs.c
@@ -151,9 +151,8 @@
link->priv = info;
info->ti = netdev_priv(dev);
- link->io.Attributes1 = IO_DATA_PATH_WIDTH_8;
- link->io.NumPorts1 = 4;
- link->io.IOAddrLines = 16;
+ link->resource[0]->flags |= IO_DATA_PATH_WIDTH_8;
+ link->resource[0]->end = 4;
link->conf.Attributes = CONF_ENABLE_IRQ;
link->conf.IntType = INT_MEMORY_AND_IO;
link->conf.Present = PRESENT_OPTION;
@@ -218,16 +217,17 @@
dev_dbg(&link->dev, "ibmtr_config\n");
link->conf.ConfigIndex = 0x61;
+ link->io_lines = 16;
/* Determine if this is PRIMARY or ALTERNATE. */
/* Try PRIMARY card at 0xA20-0xA23 */
- link->io.BasePort1 = 0xA20;
- i = pcmcia_request_io(link, &link->io);
+ link->resource[0]->start = 0xA20;
+ i = pcmcia_request_io(link);
if (i != 0) {
/* Couldn't get 0xA20-0xA23. Try ALTERNATE at 0xA24-0xA27. */
- link->io.BasePort1 = 0xA24;
- ret = pcmcia_request_io(link, &link->io);
+ link->resource[0]->start = 0xA24;
+ ret = pcmcia_request_io(link);
if (ret)
goto failed;
}