powerpc: Hardware breakpoints rewrite to handle non DABR breakpoint registers
This is a rewrite so that we don't assume we are using the DABR throughout the
code. We now use the arch_hw_breakpoint to store the breakpoint in a generic
manner in the thread_struct, rather than storing the raw DABR value.
The ptrace GET/SET_DEBUGREG interface currently passes the raw DABR in from
userspace. We keep this functionality, so that future changes (like the POWER8
DAWR), will still fake the DABR to userspace.
Signed-off-by: Michael Neuling <mikey@neuling.org>
Signed-off-by: Benjamin Herrenschmidt <benh@kernel.crashing.org>
diff --git a/arch/powerpc/mm/fault.c b/arch/powerpc/mm/fault.c
index 3a8489a..229951f 100644
--- a/arch/powerpc/mm/fault.c
+++ b/arch/powerpc/mm/fault.c
@@ -249,8 +249,8 @@
#if !(defined(CONFIG_4xx) || defined(CONFIG_BOOKE) || \
defined(CONFIG_PPC_BOOK3S_64))
if (error_code & DSISR_DABRMATCH) {
- /* DABR match */
- do_dabr(regs, address, error_code);
+ /* breakpoint match */
+ do_break(regs, address, error_code);
return 0;
}
#endif